Remove transport safeguardWhat to do if ...
The appliance and the interior fittings are protected for transport.
Correcting Malfunctions
" Pull off the adhesive tape on the left and right side of the door.
A malfunction may be caused by only a minor fault that you can rectify
" Remove all adhesive tape and packing pieces from the interior of the
yourself using the following instructions. Do not perform any other work on
appliance.
the appliance if the following information does not provide assistance in
your specific case.
InstallationWarning! Repairs to refrigerators/freezers may only be performed by quali-
fied service engineers. Improper repairs can give rise to significant hazards
Installation Locationfor the user. If your appliance needs repairing, please contact your speciali-
st dealer or our Customer Service.
The appliance should be set up in a well ventilated, dry room.
MalfunctionPossible CauseRemedy
Energy use is affected by the ambient temperature. The appliance should
thereforeAppliance is not switched on Switch on the appliance.
not be exposed to direct sunlight;Mains plug is not plugged in
Insert mains plug.
or is loose.
not be installed next to radiators, cookers or other sources of heat;Appliance does not work, no
Check fuse, replace if neces-
pilot light is illuminated.Fuse has blown or is defective.
only be installed at a location whose ambient temperature corresponds tosary.
the climate classification, for which the appliance is designed.Mains malfunctions are to be
Socket is defective.
corrected by an electrician.
The climate classification can be found on the serial plate, which is located
Green light does not light up,
at the left on the inside of the appliance.
yellow light lights up whenPlease inform your customer
The following table shows which ambient temperature is correct for eachGreen light faulty.
fast freeze fuction is activa-service
climate classification: each climate classification:ted, appliance is on.
Yellow light does not light up,
Please inform your customer
Climate classificationfor an ambient temperature of
when fast freeze fuction isYellow light faulty.
service
activated, appliance is on.
SN+10 bis +32 °CTurn the temperature regula-
Appliance cools too much.Temperature is set too cold.tor to a warmer setting tem-
N+16 bis +32 °C
porarily.
ST+18 bis +38 °C
Temperature is not properlyPlease look in the "Initial Start
adjusted.Up" section.
T+18 bis +43 °C
Open the door only as long as
Door was open for an exten-
If installation next to a source of heat is unavoidable, the following mini-necessary. Press the fast free-
ded period.
mum clearances must be maintained at the sides of the appliance:ze switch
for electric cookers 3 cm;The freezer temperature is notA large quantity of warm food
sufficient, red light lights up,was placed in the appliancePress the fast freeze switch
for oil and coal fired ranges 30 cm.
temperature signal soundswithin the last 24 hours.
If these clearances cannot be maintained a heat insulating pad is requiredThe appliance is near a heatPlease look in the "Installation
between the cooker and the refrigeration appliance.source.location" section.
If the refrigeration appliance is installed next to another refrigerator or free-Switch on the fast freeze swit-
zer a clearance of 5 cm at the sides is required, in order to prevent the for-Disturbance on the appliancech, keep the freezer closed,
mation of condensation on the outside of the appliance.inform your customer service
2433 |
ACEC
