Installation
Installation Location
The appliance should be set up in a well ventilated, dry room on a firm and
level surface.
Warning! The appliance may not be exposed to spray or water splashes.
There is a danger of electrical shock!
Energy use is affected by the ambient temperature.
The appliance should therefore
not be exposed to direct sunlight;
not be installed next to radiators, cookers or other sources of heat;
only be installed at a location whose ambient temperature corresponds
to the climate classification, for which the appliance is designed.
The climate classification is stipulated on the serial plate which can be
found on the inner side of the lid. The following table shows which ambient
temperature is correct for each climate classification:
Climate classificationfor an ambient temperature of
SN+10 to +32 °C
N+16 to +32 °C
ST+18 to +38 °C
T+18 to +43 °C
The freezer needs air.
The side walls become warm whilst the appliance is on. The heat is
generated by the special refrigerating system (shell condenser) and helps
prevent condensation and thus rust from forming on the side walls. In
order for the heat to be able to be dissipated, air must be able to circulate
around all the side walls.
Attention! To function correctly the appliance requires good ventilation.
Make sure that the side walls and the base of the appliance are not
covered or obstructed.
7 |
ACEC
