GB
Fig. 6Fig. 6 A
grill
working lightRLF
M
H
1P
G
I
2
3R
8
4G
765
F
Fig. CFig. D
L
Fig. 6 BA
second
levelTURNSPIT single
480 mm
For utilization of the turnspit follow the instructions described .
SURFACE BAKING GRILL- Put the food in spit L (see fig. 7), paying attention to block it within
240 mm (480x240)
the two forks F and to balance it, in order to avoid any unnecessary
NOTE:effort in motor R.
The grill must be used with the door half-open (see fig5 A).- Put the spit on support G, after having put its opposite end into
Fit the deflector S onto the centring pins N on the top of the oven
hole P of motor R.
opening (fig.5 B ). Then gently close the oven door against the
- Place the drip-tray with a little water under the spit.
deflector. For some models, the turnspit must be used with the oven
140
door open; in this case, fit the deflector S onto the centring
Use of the electric grill with the oven door closed
pins N on the top of the oven opening (fig.5 B ).
Some models are designed for the grill to be used with the oven
- To remote the spit, operate in the opposite direction using knob
door completely closed.
250170In this case the deflector S shown in fig. 5B is notS and protecting glove in isolating wool (fig.7).
210
supplied.
Fig. 5 AFig. 5 B
R
P
N
S
F
L
S
Fig. 7G
USE OF THE TURNSPIT
For the functions of the turnspit turning the knob on the position
(fig E) or on the symbol (fig C) when the thermostat is
separate or, in some models, press the marked button with the
INSTRUCTIONS FOR USE OF CONTROL DEVICES
symbol .
(ACCORDING TO THE MODELS)
TURNSPIT multilpe
For utilization of the turnspit follow the instructions described.
- Thread the chicken or the cubes of meat for roasting on theMINUTES COUNTERS (Fig.8 )
spit L , ensuring that it is gripped safely between the twTurn the knob cloco forks and balancing it properkwise to set the desired cooking timely to avoid unnecessar.y strain on the
trasmission R (fig 6).
The minutes minder can be adjusted from 1 to 60 minutes.
- Put the spit on the support G, after having introduced its
A sound signal will inform you that the chosen time is up.
opposite end in the socket P of the transmission R (fig 6)
- Put the support G completely into the oven so that the bar I
goes into the socket H of the turnspit motor M (fig 6A).55
5
- Place the drip-tray with some water under the turnspit, on the
50
lowest level.10
- For some models, the turnspit must be used with the oven door45
open; in this case, fit the deflector S onto the centring pins N15
on the top of the oven opening (fig.5 B ).40
- when removing the spit, wear oven mitts, pull out support G20
35
and use the handgrip A operating in the contrary way (fig 6B).25
30
Fig. 8
PCI "Campanil"TR 259 Analogic
Setting the clock
1
Press the control knob and turn clockwise.
2
3Alarm programme adjustement
8
4Turn the knob clockwise without pressing it in. At the end of the
75
6
programmed time an alarm will sound. To cancel it, turn the knob
to the bell.
Fig. E
55 |
ACEC
