822 949 308 DB_5020_5040.book Seite 12 Dienstag, 19. Juli 2005 4:46 16
g
Please check the mains cord from time lights up (Figure 1/J); it goes out when
to time for damage! Special tools are the temperature set has been reached.
required to repair a damaged mains However, if the temperature selector
cord. If the supply cord is damaged, it (Figure 1/N) is turned back, please note
must be replaced by the manufacturer, that it takes a while for the soleplate
its service agent or similarly qualified to cool down. Only when the power
persons in order to avoid a hazard.indicator light comes on again has the
Repairs to this appliance may only be soleplate reached the cooler tempera-
carried out by qualified service engi-ture.
neers. Considerable danger may result
from improper repairs. If repairs
Dry Ironing
become necessary, please contact the
Customer Care Department or your 0 Set the steam selector (Figure 1/F) to
authorised dealer.position ?0? (Figure 4/A).
0 Turn the temperature selector
Technical Data(Figure 1/N) to the desired tempera-
ture.
Power consumption:
2200 W (DB 5040)
Steam Ironing
2000 W (DB 5020)
Mains voltage: 220 - 240 VFilling the Steam Iron (Figure 3)
This appliance complies with the follo-The water reservoir should only be fil-
;
led when the plug has been removed
wing EU Directives:
from the socket.
- 73/23/EEC of 19.02.1973 ?Low
voltage directive?, including modifi-0 Set the steam selector to position
?0? = dry iron (Figure 4/A) and hold
cation directive 93/68/EEC.
the appliance upright.
- 89/336/EEC of 03.05.1989 ?EMC
0 Fill the water reservoir at most to the
directive?, including modification
?MAX? mark. To do this, you can use
directive 92/31/EEC.
the measuring beaker supplied
(Figure 1/P).
Using for the First Time
Water Quality
Setting the Temperature
You can use tap water up to 3 mmol/I
(Figure 2)17° dH water hardness level. Your local
Please note the internationally appli-Water Authority can advise you on the
cable care symbols on garment labels. hardness of the water in your area. If
On good quality garments they indi-the water from your tap is harder than
cate the correct ironing temperatures.the above, please use distilled water
available from a chemist or a 50:50
The ironing table indicates which tem-
mixture of tap water and distilled
perature is most appropriate for a par-
water. Never use battery water under
ticular type of fabric. We recommend
sorting the washing first. Start with any circumstances!
materials that require low temperature When using for the first time,
ironing (e.g. PERLON). Follow on by
please note:
ironing materials that require progres-
0 Fill the reservoir with water; set the
sively higher temperatures. In this way
steam selector (Figure 1/F) to position
you avoid damaging sensitive fabrics
?4? (Figure 4/B).
by using too high a temperature. When
switched on, the power indicator lamp
12 |
ACEC
