Switching on the hood - Fig. 3press towards the
bottom to switch on
The control ball is a balancer switch.the hood.
Pressing the control ball repeatedly towards
the bottom, switches on the hood and you
may select the motor level desired,
depressing once again the hood switches
off.
Switching on the light - Fig. 3
Press the control ball towards the top :
once for submersed lighting,
once again for full lighting,
press again to switch off the light.
Indicator light for grease orpress towards the
top to switch on
charcoal filterthe lights
The air duct, in this hood, includes a device
Fig. 3
that signals when the filter requires cleaning
or changing .
Led signal for grease filter
The LED signal flickers (flickering green light) when the grease filter
requires cleaning, occurs at about 40 operating hours.
Ensure that the indicator light is checked each time the hood is used.
Led signal for charcoal filter
The LED signal flickers (flickering orange light) when the charcoal filter
requires cleaning, occurs at about 160 operating hours.
Ensure that the indicator light is checked each time the hood is used.
Re-setting the saturation signal
After cleaning or replacing the filter, select the intensive speed (the
control ball lights up with a red flashing light), press again and hold
depressed for about 3 seconds until an audible signal indicates the
reset has taken place.
8 |
ACEC
