ABOUT THE REMOTE CONTROLRemote control operation
Inserting batteriesThis remote control system allows you to operate other external
Detach the battery cover on the rear of the remote control andequipment besides the AIWA receiver. For details of the remote
insert two R6 (size AA) batteries.control operation for other external equipment, see OREMOTE
CONTROL � on page 20.
The following is an explanation on how to operate the AIWA
receiver and the AIWA DVD players.
PREPARATIONS
When to replace the batteries
The maximum operational distance between the remote control
and the sensor on the unit should be approximately 5 meters
(16 feet). When this distance decreases, replace the batteries
with new ones.
Important
Y The ENTER buttons on the remote control do not
substitute for the ENTER button on the main unit.They 1 Press the AIWA RECEIVER button to set the
are for operating AIWA DVD players or other audio/videoremote control to the AIWA receiver mode.
equipment.
Y In principal, the UP and DOWN buttons on the remote control2 Press one of the buttons indicated above.
substitute for the N and M buttons on the main unit
except when selecting the TUNER function.
FUNCTION button
Each time this button is pressed, the sound source changes
NOTEcyclically.
YIf the unit is not going to be used for an extended period ofTUNER PRESET/SURROUND buttons
time, remove the batteries to prevent possible electrolyteEnEnEnEnEnTune in the station which has been preset on the receiver.
leakage.To go to a higher preset number, press the UP button. To go to
YThe remote control may not operate correctly when:a lower preset number, press the DOWN button.
- The line of sight between the remote control and the remoteThis button is also used when adjusting the speaker level
sensor in the display window is exposed to intense light, suchEEEEE (Espan(Espan(Espan(Espan(Espanooooobalance of DOLBY SURROUND, DTS SURROUND or DSP
as direct sunlight.
- Other remote controls are used nearby (those of a television,surround etc.
etc.)
FFFFF (Franç (Franç (Franç (Franç (FrançaaaaaNOTE
It is not necessary to press the AIWA RECEIVER button each
time you operate the AIWA receiver unless another mode has
already been set. (See OREMOTE CONTROL � on page 20.)
Operating AIWA DVD players
You can control basic functions of AIWA DVD players with the
remote control. In principle, the AIWA DVD buttons have the same
function as those on the DVD players.
For more details, refer to the operating instructions of the player.
If the receiver cannot be operated with the remote
control
Follow the steps below using the remote control.
1 Press the AIWA RECEIVER button.
2 Press and hold the SET UP button for about 3
seconds.
The indicator on the top of the remote control blinks twice
while pressing the button.
3 Press the DIGIT buttons in the orO0,der of � O4,�
O0� and O6.�
ENGLISH 6 |
ACEC
