2 Press the DOLBY PRO LOGIC button again and hold it down until the center speaker mode to be selected
appears.
When selecting the DOLBY PRO LOGIC mode in step 1:
"NORMAL", "WIDE" and "PHANTOM"p apear in turn.
When selecting the 3CH LOGIC mode in step 1:
"NORMAL" and "WIDE" appear one after another.
NOTE
? Depending on the sound source or listening condition, surround effect may not be obtained even when the DOLBY
PRO LOGIC is on.
? The full DOLPRBO LY OGIC effect cannot be obtained when using the software without
mark. In this case, use the DSP surround system instead (see page 8).
? The DOLBY PRO LOGIC system is automatically canceled when the BBE or DSP system is turned on.
DOLBY PRO LOGIC (cont.) pg. 13
A DJUSTING SPEAKER LEVEL BALANCE
The unit is equipped with a built-in test signal generator called a noise sequencer for easy balance adjustment of all
four channels. The sequencer outputs a noise signal that "travels" from channel to channel, enabling the simple
adjustment of soel tound le achv ieve the same apparent loudness, at your listening position, from each channel.
1 Select the Dolby Pro Logic mode according to your current type and placement of the speakers.
(See page 12.)
2 Press the MANUAL SELECT button and hold it dooutw tn fwoo secor ab nds until "L TEST" appears. |
ACEC
