Safety Precautions
On power sources
YAC power cord must be changed only at the qualified serviceW ARNING: TO PREVENT FIRE OR ELECTRIC SHOCK
HAZARD, DO NOT EXPOSE THIS PRODUCT TO RAIN OR
shop.MOISTURE.
W ARNING: Do not install this equipment in a confined spaceOn placement
Y Place the receiver in a location with adequate ventilation to
such as a book case or similar unit.prevent heat build-up in the system.
To prevent fire, do not cover the ventilation of the apparatus
with news papers, table-cloths, curtains, etc. And donOt placeY At high volume, over long periods of time, the cabinet
becomes hot to the touch. This is not a malfunction.
lighted candles on the apparatus.However, touching the cabinet should be avoided. Do not
DonOt throw away the battery with generalplace the unit in a confined space where ventilation is poor
house waste, dispose of it correctly as chemicalas this may cause overheating.
waste.Y Do not block the ventilation slots by putting anything on the
system. The receiver is equipped with a high power amplifier.
If the ventilation slots on the top surface are blocked, the unit
This appliance is classified as a CLASS 1can overheat and malfunction.
LASER product. The label is located on theY Do not place the system on a soft surface such as a rug
rear exterior.that might block the ventilation holes on the bottom.
Y Do not place the system in a location near heat sources, or
CAUTION:in a place subject to direct sunlight, excessive dust, or
This DVD Receiver employs a Laser System.mechanical shock.
To ensure proper use of this product, please read this ownerOs
On operation
manual carefully and retain it for future reference. Should theY If the system is brought directly from a cold to a warm loca-
unit require maintenance, contact an authorized service loca-tion, or is placed in a very damp room, moisture may con-
tion (see service procedure).dense on the lenses inside the system. Should this occur,
Performing controls, adjustments, or carrying out proceduresthe system may not operate properly. In this case, remove
other than those specified herein may result in hazardous rthe disc and leaadi-ve the system turned on for about half an
ation exposure.hour until the moisture evaporates.
To prevent direct exposure to laser beam, do not trYy to openWhen you move the system, take out any discs. If you donOt,
the enclosure. Visible laser radiation when open. DO NOthe disc maTy be damaged.
STARE INTO BEAM.
The nameplate is located on the rear of the unit.
CAUTION: The apparatus should not be exposed to water
(dripping or splashing) and no objects filled with liquids, such
as vases, should be placed on the apparatus.IMPORTANT NOTICE
Caution: This system is capable of holding a still video
Precautionsimage or on-screen display image on your television screen
Safetyindefinitely. If you leave the still video image or on-screen
Y If anything falls into the cabinet, unplug the unit and hadisplay image displave it yed on your TV for an extended period
checked by qualified personnel before operating it anof time yy ou risk permanent damage to your television
further.screen. Projection televisions are especially susceptible to
Y The unit is not disconnected from the AC power source this.
(mains) as long as it is connected to the mains outlet, even if
the unit itself has been turned off.
Y Unplug the unit from the wall outlet if you do not intend to
use it for an extended period of time. To disconnect the cord,
pull it out by the plug, never by the cord.
Installing
Y Allow adequate air circulation to prevent internal heat
buildup.
Y Do not place the unit on surfaces (rugs, blankets, etc.) or
near materials (curtains, draperies) that may block the venti-
lation slots.
Y Do not install the unit near heat sources such as radiators, or
air ducts, or in a place subject to direct sunlight, excessive
dust, mechanical vibration, or shock.
Y Do not install the unit in an inclined position. It is designed to
be operated in a horizontal position only.
YKeep the unit and discs away from equipment with strong
magnets, such as microwave ovens, or large loudspeakers.
Y Do not place heavy objects on the unit.
Y If the unit is brought directly from a cold to a warm location,
moisture may condense inside the DVD Home Theatre
System and cause damage to the lenses. When you first
install the unit, or when you move it from a cold to a warm
location, wait for about 30 minutes before operating the unit.
2 |
ACEC
