DOLBY SURROUND AND DTS SURROUND
This unit is equipped with the Dolby Pro Logic decoder4Press SURROUND., Dolby
Digital decoder and DTS decoder .Pressing the button changes the surround mode according to
The unit and the center and surround speakers (standard) assurethe type of the input signal, as follows.
full-scale home theater sound. When playing back discs or video
software that have been recorded in Dolby Pro Logic, Dolby DigitalIn case Dolby Digital or DTS multichannel source is input:
surround or DTS surround, astonishingly realistic sound
DOLBY D or DTS2chSTEREO
surrounds the listener to create a new level of audio/visual
entertainment.
In case Dolby Digital 2-channel source or other source is input:
Independent control of the five channels allows the listener to
enjoy the same type of sound reproduction experienced in moviePRO LOGIC2chSTEREO
SURROUND
theaters. V oices are reproduced in the front and center sound
field, while ambient sounds like cars and crowds are reproducedThe following indicators light according to the input signal and
other conditions.
on all sides of the listener for an incredibly lifelike audio/video
experience.hDIGITAL : Dolby Digital signal is input.
dts : DTS source signal is input.DOLBY SURROUND AND DTS
hPRO LOGIC : 2-channel source is played with surround set
to on.
TURNING SURROUND ON AND
If you feel that the surround effect is not sufficient
Surround playback is af fected by many factors. Check the
OFF
following points.
YAre settings made correctly according to the connected
speakers and their position?
YIs the DVD digital out signal correctly selected?
YIn Dolby Digital and DTS, there are multi-sources other than
SURROUND
5.1ch. Confirm the type of the source being played.
YA disc may contain multiple audio tracks. Confirm the audio
INPUT
track being played.
MODE
YDolby Digital and DTS sources can be enjoyed only when
connections are made in digital.
SURROUND
NOTE
YThis unit supports input signals of the Dolby Digital surround
FUNCTION
bit stream, DTS surround bit stream and linear PCM whose
INPUT MODEsampling frequency is 32 kHz, 44.1 kHz and 48 kHz.En
YWhen connecting some DVD players to the receiver through
the digital in terminals, noise may be heard in the DVD operation:
e.g. searching a disc, skipping a chapter .
Check the followings:
YBefore enjoying Dolby surround or DTS surround, set the
speaker existance, size and distance (see page 14), and
adjust the speaker sound levels to the proper balance (see
page 15).
YMake sure the speakers are properly connected and positioned
(see pages 5 and 6).
YMake sure the TV set and video unit are properly connected
(see page 4).
YMake sure the disc and video tape, etc., support Dolby Pro
Logic, Dolby Digital surround or DTS surround.
YWhen connecting an LD player equipped with the AC-3 RF OUT
terminal, use an RF demodulator unit. Also connect the analog
AUDIO OUT terminals of the LD player to the receiver to play
all the sources. For further information, refer to the instructions
of the LD player .
1Turn FUNCTION to select a function.
2 Press INPUT MODE to select ODIGITAL� or
OANALOG�.
Select in accordance with the connected equipment and sound
source to be played.
3Play the surround source by the connected
equipment.
ENGLISH 13 |
ACEC
