VOLUME
MIC VOLNUP, MDOWNDISPLAY
MICEQEQ
PHONESQSOUNDVOL i, k
r, tREPEAT/r, t
OSC/SLEEP
GENERAL
SOUND ADJUSTMENTSETTING THE SLEEP TIMER
Volume or tone adjustment does not affect recording.The unit can be turned off automatically at a specified
time.
VOLUME (VOL)
Press VOLUME N UP or M DOWN. The volume1Keep REPEAT/OSC/SLEEP pressed until
level is displayed as a number from 0 to 19.OY 1� flashes in the display.
O1� in the display indicates the level 1 and OY 1�
indicates the level 11.
Y The volume level is automatically set to 9 if theThe dot and number flash.
power is turned off when the volume level is set to
10 or more. (except when turning the power back2Within 4 seconds, press r or t to
on within 4 seconds)
Y Pressing DISPLAY on the remote control displaysspecify the time until the power is turned
the adjusted volume level.off.
Each time it is pressed, the time changes between
3-mode EQ (equalizer)10 and 90 minutes in 10-minute steps.
Press EQ repeatedly until the desired mode is
displayed.Example: The unit will turn off after 30 minutes.
The equalizer mode changes to ROCK, POP, JAZZ(off)
or no equalization, cyclically.12390
ROCKPOPJAZZ
While the sleep timer works
the dot keeps flashing.
ROCK - Emphasizes the high and low range of
music.The volume level or a
POP - Emphasizes voice and midrange of music.CD track number.
JAZZ - Emphasizes the low range of music.
To check the time remaining until the power is
QSOUND systemturned off
This system provides a rich, three dimensional soundRepeat step 1 shown above. The remaining time is
displayed for 4 seconds.
area for stereo sources.
You can enjoy more enhanced sound.To cancel the sleep timer
Press QSOUND and the QSOUND indicator lights up.Display the remaining time and press r or t
Y At higher volumes, turning QSOUND on may causerepeatedly until (off) is displayed.
sound distortion. In this case, make the volume
down.
NOTE
If the unit is turned off during tape playback, c on the
deck will not be released. Press Z to release c.
10 ENGLISH |
ACEC
