GETTING STARTEDTheft protection
NoteTake the front panel with you when leaving the
Some buttons on the unit are assigned two or morecar, and keep it in the supplied carrying case.
functions. For detailed descriptions, refer to the
related pages.Caution alarm
If you turn off the ignition switch to the OFF
position without removing the front panel, the
Resetting the unitcaution alarm will beep for a few seconds.
Before operating the unit for the first time, or afterIf you connect an optional amplifier and do not use
replacing the car battery or changing thethe built-in amplifier, the beep tone will be
connections, you must reset the unit.deactivated.
Remove the front panel and press the reset button
with a pointed object, such as a ballpoint pen.To detach the front panel
Front panel detached1Press Z to remove the disc.
2Press (OFF)*.
3Press , then pull it off towards you. (Hold
the panel with one hand to prevent
accidentally dropping it.)
(OFF)
Reset button
Note
Pressing the reset button will erase the clock and
some memorized functions.
DEMO (demonstration) mode
The unit has an extra display (DEMO) mode which
demonstrates the illumination modes of the unit.* If your car has no ACC position on the ignition
When you deactivate the unit by pressing (OFF),switch, be sure to turn the unit off by pressing
the clock is displayed for about 10 seconds, then(OFF) until the display disappears to avoid car
the unit switches to DEMO mode.battery drain.
To cancel DEMO mode
1While in DEMO mode, press and holdTo attach the front panel
(PUSH-MENU) until OSET� appears on the1Engage the right side of the front panel to
display.the right catch on the unit.
2Push the panel forward until it locks.
2Press (SEEK) (+) or (SEEK) (�) to selectBe sure not to press any buttons and the
ODEMO.�display window.
3Turn (PUSH-MENU) to select ODEMO OFF.�
To resume DEMO mode, repeat the above and
select ODEMO ON� at step 2.
1
2
Notes
YIf you detach the panel while the unit is still
turned on, the power will turn off automatically
to prevent the speakers from being damaged.
YDo not subject the front panel to heat/high
temperature or moisture. Avoid leaving it in a
parked car or on a dashboard/rear tray.
YDo not put anything on the inner surface of the
front panel.
4 |
ACEC
