Adjusting sound
Setting the clock
You can select the following modes for adjusting sound1Press and hold DISP until the clock indicator
depending on the music you listen to: BASS (low
frequencies), TRE (high frequencies), BAL (left/right),flashes on the display.
FAD (front/ rear) , H-BASS (high bass) and2Press i (to set hour) or k (to set minute), and
BBE(enhances the clarity of high-frequency sound).then turn AUDIO CONTROL.
3Press DISP.
1Press SEL repeatedly to select the mode to be
adjusted.
Pressing SEL cycles through the modes. TheDisplaying the clock
selected mode?s indicator flashes.1Press DISP.
2Turn AUDIO CONTROL to increase/decrease the
To return to the former display, press DISP again.
level or to select on/off or on1/on2/off for the
selected mode.
NoteRADIO OPERATION
Adjust the level or select on/off within 5 seconds, or the
selected mode will return to previous state.Tuning in to a station
(Seek/Manual Tuning)
Aligning the source levels
LO
(Source Level Adjuster)
Volume may vary each time you change the source
mode. In this case, you can align each source mode?s
volume to almost the same level.
1Press SRC or BAND repeatedly to select the desired
mode.
i/k BAND
2Press DISP while pressing SEL.
?LA 0? appears on the display.Stereo indicator Local indicator
3Turn AUDIO CONTROL to adjust the level.
Note
Adjust the level within 5 seconds, or the selected mode
will be canceled.
Band indicator Frequency indication
Restoring the factory settings
1Press BAND repeatedly to select the desired band
1Turn off the unit.(FM1, FM2, FM3, AM1, or AM2).
2Press and hold DISP until ?LA --? appears on the2*Press i (to move to higher frequencies) or k (to
display.move to lower frequencies) to tune in to a station.
?ST? appears on the display when an FM station is
Notebroadcasting in stereo, and receiving conditions are
You can restore the factory settings only for VOL, BASS,good.
TRE, BAL, FAD, H-BASS, and BBE, and aligned source*Seek Tuning and Manual Tuning
volume levels.? Press and hold i or k until seek Tuning starts.
The unit locates a station automatically (Seek Tuning).
Muting button beep sounds? Press i or k repeatedly to search for a desired
station while increasing or decreasing the frequency
1Turn off the unit.step by step (Manual Tuning).
2Press and hold SEL until ?bEEP? appears on theTo stop Seek Tuning, press i or k again.
display.
3Turn AUDIO CONTROL to select on (level indicators
appear) or off (level indicators disappear).
4Press SEL.
33 ENGLISH ENGLISH |
ACEC
