BASIC OPERATION,1Press SEL repeatedly to select the mode to be
adjusted.
AUDIO AND CLOCKPressing SEL cycles through the modes. The
selected modeOs indicator flashes.
ADJUSTMENT
2Turn AUDIO CONTROL to increase/decrease the
level or to select on/off for the selected mode.
PWR/MUTESEL
Note
AUDIO CONTROL
Adjust the level or select on/off within 5 seconds, or the
selected mode will return to previous state.
Aligning the source levels
(Source Level Adjuster)
i/kDISPSRC
Volume may vary each time you change the source
BANDmode. In this case, you can align each source modeOs
volume to almost the same level.
Turning the unit on/off
1Press SRC or BAND repeatedly to select the desired
YPress PWR/MUTE to turn on the unit. The unit alsomode.
turns on when you insert a CD.2Press DISP while pressing SEL.
YPress and hold PWR/MUTE until the unit turns off.OLA 0� appears in the display.
3Turn AUDIO CONTROL to adjust the level.
Note
Most operations described in this manual require theNote
unit to be turned on before starting the operation,Adjust the level within 5 seconds, or the selected mode
unless explicitly stated otherwise.will be canceled.
Changing the source modeRestoring the factory settings
1Press SRC.1Turn off the unit.
ENGLISH
Pressing SRC cycles through source modes in the2Press and hold DISP until OLA --� appears in the
following order:display.
FM1 (FM2/FM3/AM1/AM2) ? CD* ? AUX
?Note
You can restore the factory settings only for VOL,
*OCD � does not appear in the display when there is no
BASS, TRE, BAL, FAD, and H-BASS, and aligned
CD in the unit.
source volume levels.
Adjusting the volume
Muting button beep sounds
1Turn AUDIO CONTROL.
1Turn off the unit.
VOL (volume) indicator flashes.
2Press and hold SEL until ObEEP� appears in the
display.
Muting the sound3Turn AUDIO CONTROL to select on (level indicators
1Press PWR/MUTE briefly.appear) or off (level indicators disappear).
MUTE indicator flashes.4Press SEL.
To restore volume, briefly press PWR/MUTE again.
Adjusting sound
You can select the following modes for adjusting sound
depending on the music you listen to: BASS (low
frequencies), TRE (high frequencies), BAL (left/right),
FAD (front/ rear) and H-BASS (high bass).
ENGLISH ENGLISH 22 |