GENERAL
SOUND ADJUSTMENTSETTING THE SLEEP TIMER
Volume or tone adjustment does not affect recording.The unit can be turned off automatically at a specified
time.
VOLUME
Press VOLUME N or M. The volume level is1Keep pressed until O30� flashes in
displayed as a number from 0 to MAX (25).the display.
Y The volume level is automatically set to 14 if the
power is turned off when the volume level is set to
15 or more. (except when turning the power back
on within 4 seconds)
En
3-MODE EQUALIZER
2Within 4 seconds, press r or t to
Press 3-MODE EQUALIZER repeatedly until the
specify the time until the power is turned
desired mode is displayed.
off.
The equalizer mode changes to R (Rock), P (Pop),
Each time it is pressed, the time changes between
J (Jazz) or no equalization, cyclically.
10 and 90 minutes in 10-minute steps.
Rock - Emphasizes the high and low range of music.
Pop - Emphasizes voice and midrange of music.
Jazz - Emphasizes the low range of music.
QSOUND system
This system provides a rich, three dimensional soundSpecified timeWhile the sleep timer works,
area for stereo sources.the dot keeps flashing.
You can enjoy more enhanced sound.
Press QSOUND and the QSOUND indicator lights up.
To check the time remaining until the power is
Y At higher volumes, turning QSOUND on may cause
turned off
sound distortion. In this case, make the volume
Repeat step 1 shown above. The remaining time is
down.
displayed for 4 seconds.
To cancel the sleep timer
Display the remaining time and press r or t
repeatedly until OFF is displayed.
NOTE
If the unit is turned off during tape playback, x on the
deck will not be released. Press Z to release x.
ENGLISH 9 |
ACEC
