PLAY WITH DOLBY PRO LOGICADDITIONAL DOLBY PRO LOGIC MODES
In addition to the NORMAL mode, this unit is also equipped with
the PHANTOM and the 3 STEREO modes.
PHANTOM mode: Use this mode when no center speaker is
connected. The center channel signals are output through the
left and right speakers.
3 STEREO mode: Use this mode when no surround speakers
are connected. This mode reproduces rear sounds through the
front speakers.
To select PHANTOM or 3 STEREO
Press DOLBY PRO LOGIC repeatedly until the desired DOLBY
PRO LOGIC mode is displayed. The DOLBY PRO LOGIC mode
is displayed cyclically as follows.
NORMALPHANTOM3 STEREO
OFF (cancel)
To adjust the balance of connected speaker sound levels
Carry out steps 2 to 4 of OADJUSTING SPEAKER LEVEL
BALANCE�.
1Press VIDEO/AUX/5.1CH and start playback of the
video source.
OVIDEO� is displayed.
Y Depending on the sound source and/or listening conditions, a
If O5.1 ch IN� is displayed, press VIDEO/AUX/5.1CH again.surround effect may not be obtained even when the DOLBY
2Press DOLBY PRO LOGIC.PRO LOGIC is on.
ONORMAL� is selected, and the playback sound has theY The full DOLBY PRO LOGIC effect cannot be obtained when
using software without H mark. In this case, use
DOLBY PRO LOGIC effect.
the DSP SURROUND system instead. (See page 11.)
To cancel Dolby Pro Logic modeY The DOLBY PRO LOGIC is automatically canceled when:
- the ECHO level is changed.
Press DOLBY PRO LOGIC repeatedly until OOFF� is displayed.
- the DSP SURROUND system or the BBE is turned on.
To change the sound levels during playback- the headphones are plugged in.
- the Karaoke function is turned on.
After adjusting the balance with the noise sequencer, the sound
levels of the center or each surround speaker can be adjusted- the 5.1 CH (page 29) is selected.
during playback of laser discs or video software.Y Set the microphone volume to OFF while the DOLBY PRO
LOGIC is on. Otherwise, the DOLBY PRO LOGIC sound cannot
1 Press MANUAL SELECT on the remote control repeatedly
to select OCEN� (center speaker), OS-L� (Left surround speaker)be reproduced correctly.
or OS-R� (Right surround speaker).
2 While the OCEN� OS-L� or OS-R� is displayed, press f DOWN
or g UP on the remote control to adjust the volume.
22 ENGLISH |
ACEC
