OTHER CONNECTIONS
SUBWOOFER JACKS
CONNECTING OPTIONAL EQUIPMENT
Connect an optional powered subwoofer with a built-in amplifier
to either of the two SUBWOOFERS jacks.
5.1 CH INPUT JACKS
This unit can input sound signals from the audio equipment (DVD
player, LD player, etc.) that contains a Dolby Digital decoder with
the 5.1 ch output terminals. Refer to OCONNECTING A DVD
PLAYER� on page 29.
LISTENING TO EXTERNAL SOURCES
Refer to the operating instructions of the connected equipment
for details.
Y The connecting cords are not supplied. Obtain the necessary
connecting cords.
Y Consult your local Aiwa dealer for optional equipment.
VIDEO/AUX JACKS
This unit can input analog sound signals through these jacks.
Use a cable with RCA phono plugs to connect audio equipment
(turntables, LD players, MD players, VCRs, TV, etc.).
Connect the red plug to the VIDEO/AUX R jack, and the white
plug to the VIDEO/AUX L jack.
When connecting a turntable
Use an Aiwa turntable equipped with a built-in equalizer amplifier.
MD JACKSTo play equipment connected to VIDEO/AUX jacks or MD jacks,
proceed as follows.
This jack is recommended to connect with an MD player.
Use a cable with RCA phono plugs.1Press VIDEO/AUX/5.1CH or MD.
Connect the red plug to the MD R jack, and the white plug to theTo play the equipment connected to VIDEO/AUX, press
MD L jack.VIDEO/AUX/5.1CH. OVIDEO� appears on the display.
To play the equipment connected to MD, press MD. OMD�
appears on the display.
LINE OUT JACKS
2Play the connected equipment.
This unit can output analog sound signal through these jacks.
Use a cable with RCA phono plugs to connect audio equipmentTo change a source name in the display
with LINE IN (analog input) jacks.When VIDEO/AUX/5.1CH is pressed, OVIDEO� is displayed
Connect the red plug of a cable to LINE OUT R jack, and theinitially. It can be changed to OAUX� or OTV�.
white plug to LINE OUT L jack.With the power on, press POWER while pressing
VIDEO/AUX/5.1CH.
Repeat the procedure to select one of the names.
Do not connect an equipment to LINE OUT jacks and VIDEO/To adjust the sound level of the external source
AUX jacks simultaneously. Otherwise, noise is generated andWhen the sound level of the external source is much higher or
malfunction occurs.much lower than that of other function sources, adjust it as follows.
1 Press VIDEO/AUX/5.1CH or MD and play the equipment.
CD DIGITAL OUT (OPTICAL) JACK2 Press f or g so that the sound level becomes the same
as that of other function sources.
This unit can output CD digital sound signals through this jack.
Use an optical cable to connect digital audio equipment (DAT
deck, MD recorder, etc.).
Remove the dust cap a from the CD DIGITAL OUT (OPTICAL)During recording, the sound level can not be adjusted.
jack. Then, connect an optical cable plug to the CD DIGITAL
OUT (OPTICAL) jack.
When the CD DIGITAL OUT (OPTICAL) jack is not being
used
Attach the supplied dust cap.
28 ENGLISH |
ACEC
