The DOLBY PRO LOGIC featureand the centerand rear2Press MANUALSELECTand hold itdown for
speakers(standard)assurefull-scalehome theatersound.Whenabout 4 seconds until?L? flashes.
playingback laserdiscsor video softwarethathave been
recorded in Dolby Surround,astonishinglyrealisticsound
surroundsthe listenerto createa new levelof audio/visual
entertainment.
Independentcontrolofthefoursoundchannelsallowsthelistener
to enjoythesame typeofsound reproductionexperiencedin
movie theaters.Voicesare reproducedinthefrontand centerA noisesignalissenttoeach channelinturninthefollowing
sound field,whileambient sounds likecarsand crowds aresequence.
reproducedon allsidesofthelistenerforan incrediblylifelike
L:Leftspeaker+CEN: Centerspeaker-R: Rightspeaker
audio/videoexperience.Pleasereadthefollowingcarefullyto
?tune?thesystem?soutputtomatch thecharacteristicsofyourSUR: Surroundspeakers<
listeningspace.
3Adjust the sound levelof the center and the
surround speakers.
Check the following:
While?CEN? or?SUR isdisplayed,press+DOWN or>
lBefore using the DOLBY PRO LOGIC, adjustthe proper
UP on theremotecontroltoadjustthevolume ofthecenter
balanceofspeaker sound levels.
or each surroundspeakerto match the levelofthe front
lMake surethesuppliedspeakersareproperlyconnectedand
speakers.
positioned.(Seepage 4 and 5)
lMake suretheTV setand videounitareproperlyconnected.
(See page 5)
lMake sure the laser disc, video tape, etc.,support
Do ~00L6vSURROUND\.
To adjustthebalancebetweentheleftand rightfrontspeakers,
see page 10.At thistime,the DOLBY PRO LOGIC mode
shouldbe canceledby pressingDOLBY PRO LOGIC until
the?PRO-OFF isdisplayed.
4Press MANUALSELECT again to stop the noise
signal.
m
When thesequenceroutputsa noisesignal,a clickingsound
mightbe heardfromthespeakersdue tothecharacteristicsof
thecircuit.Thisisnotmalfunction.
About the channels
The leftand rightfrontspeakers createthestereoeffect.
The centerspeaker helpsachieveprecisesound positioning
overa broadsound field.
1?~k8/
]iThe rear-mountedsurround speakersenhance the?depth?of
._________.?????_?
thesound field.
To change the delay time
The surroundspeakersreproducesounds a splitsecond after
The unitisequippedwitha built-intestsignalgeneratorcalledathe frontspeakers. The delay is initiallyset to 20 ms
noisesequencerforeasy balanceadjustmentofall4 channels.(milliseconds).
The sequenceroutputsa noisesignalthat?travels?fromchannelTo change thisstandarddelaytime,pressMANUALSELECT
to channel,enablingthe simpleadjustmentofsound leveltoon theremotecontrolrepeatedlyuntil?TIME isdisplayed.Then,
achieve,atthelisteningposition,thesame apparentloudnesspress~DOWNor -UP, Each timeone ofthebuttonsis
fromeach channel.pressed,thedelaytimechanges as shown below.
Use theremotecontrol.15mS+20mS++30mS
1PressDOLBYPRO LOGIC to select?NORMAL?.
?NORMAL? isdisplayed.
If?PHANTOM? or ?3 STEREO? isdisplayed,pressDOLBY
PRO LOGIC repeatedlyuntil?NORMAL? isselected.
20ENGLISH |
ACEC
