TIMER
SETTING THE CLOCKSETTING THE SLEEP TIMER
When the AC cord is connected for the first time, the clock on
the display flashes.
Set the time as follows while the power is off.The receiver can be automatically turned off at a specified time.
1 Press the ENTER button.1 Press the AIWA RECEIVER button.
The display becomes a little brighter.2 Press the SLEEP button.
2 Within 4 seconds, turn the MULTI JOG to
designate the hour and the minute.The unit will be turned off after about 60 minutes.
The time advances by turning it to the right, and decreases
by turning it to the left.To specify the time until the power is turned off
The N or M button on the main unit is also availablePress the UP or DO. PressWN button repeatedly within four seconds
the button repeatedly. To change the time rapidly in 10-minafter step 2.ute
steps, hold it down.Each time the button is pressed, the time changes between 5
and 240 minutes in 5-minute steps.
3 Press the ENTER button.
The clock starts from 00 seconds.
NOTE
When the clock is set for the first time after purchase
Everything on the display will clear.Specified time
This is because the power economizing mode of the unit is
activated, and is not a malfunction.
The power economizing mode can be canceled. See page 7 for
details.To check the time remaining until the power is turned off
To correct the current timePress the SLEEP button once. The remaining time is displayed
Press the POWER button to turn the unit off. Carry out steps 1for four seconds.
to 3 above.To cancel the sleep timer
Press the SLEEP button twice so that OSLEEP � on the display
To display the current timedisappears.
Press the CLOCK button on the remote control. The clock is
displayed for 4 seconds.
When the power is off in the power economizing mode, pressing
the ENTER button on the unit also displays the current time for 4
seconds.
To switch to the 24-hour standard
Display the current time, and press the DIGITAL/ANALOG/BAND
button on the unit within 4 seconds.
Repeat the same procedure to restore the 12-hour standard.
In the 12-hour standard, OAM 12:00� indicates midnight and OPM
12:00� indicates noon.
If the clock display flashes while the power is off
This is caused by a power interruption. The current time needs
to be reset.
If power is interrupted for more than approximately 24 hours, all
settings stored in memory after purchase need to be reset.
21 ENGLISH |
ACEC
