Mounting the hood body
Before attaching the hood body, tighten the two
screws Vr located on the hood body mounting
points.
Hook the hood body onto the screws 12a
Fully tighten support screws 12a
Adjust screws Vr to level the hood body.
Connections
DUCTED VERSION AIR EXHAUST SYSTEM
When installing the ducted version, connect the hood to the chimney using either a flexible or rigid pipe
o 150 or 120 mm, the choice of which is left to the installer.
To install a o 120 mm air exhaust connection,
insert the reducer flange 9 on the hood body out-
let.
Fix the pipe in position using sufficient pipe clamps
(not supplied).
Remove any activated charcoal filters.
Lateral air exhaust on ducted version (connection to exhaust flue above wall cupboards)
Assemble the half-shells of the hood body
extension piece 14.
Push fit the assembled hood body extension 1415
onto the air exhaust outlet.
Insert the deflector 16 into the air exhaust fitting
15 to close off the unused outlet.
Push fit connection piece 15 to the hood body
extension piece 14, ensuring that the free end14
matches up with the opening of the required outlet
duct.
Remove any activated charcoal filters
16
GB17 |
ACEC
