RECIRCULATION VERSION AIR OUTLET
Assemble the two halves of the hood body extension piece 14.14.14.14.14.
Push fit the assembled hood body extension piece 1414141414 onto the air outlet.
Push fit connection 1515151515 onto the hood body extension piece 14.14.14.14.14.
Insert the connection extension pieces laterally
14.114.114.114.114.1 in connection 15.15.15.15.15.
Make sure that the outlet of the extension
pieces 14.114.114.114.114.1 is horizontally and vertically
aligned with the chimney outlets. If this is not
the case, adjust the position by either reversing
the connection extension pieces 14.114.114.114.114.1 or by
cutting the hood body extension 1414141414 along one
of the thinner section channels denoting the
pre-fixed lengths, then reassemble as
described previously.
The air outlet directional grills 8a - 8b8a - 8b8a - 8b8a - 8b8a - 8b must
be fitted after the lower outlet duct has been
installed.
Ensure that the activated charcoal filters have been inserted.
ELECTRICAL CONNECTION
Connect the hood to the mains through a two-pole
switch having a contact gap of at least 3 mm.
Remove the grease filters (see paragraph
Maintenance) being sure that the connector of the
feeding cable is correctly inserted in the socket
placed on the side of the fan.
Flue assembly
Upper exhaust flueUpper exhaust flueUpper exhaust flueUpper exhaust flueUpper exhaust flue
Slightly widen the two sides of the upper flue
and hook them behind the brackets 7.2.17.2.17.2.17.2.17.2.1,
making sure that they are well seated.
Secure the sides to the brackets using the 4
screws 12c12c12c12c12c (2,9 x 9,5) supplied.
Lower exhaust flueLower exhaust flueLower exhaust flueLower exhaust flueLower exhaust flue
Slightly widen the two sides of the flue and
hookthem between the upper flue and the
wall, making sure that they are well seated.
Fix the lower part laterally to the hood body
using the 2 screws 12c12c12c12c12c (2,9 x 9,5) supplied.
On the recirculation version, fit the directional
grids 8a - 8b8a - 8b8a - 8b8a - 8b8a - 8b in their housings making sure
that the directional symbols are towards the
top and front of the hood. Also make sure that
they are correctly inserted in the connection
extension pieces 14.114.114.114.114.1.
12c12c12c12c12c
GB18 |
ACEC
