Basic Operation
PWRBBE8
RESET
MODEc9
Detaching the Front PanelConnectable to Remote Control Interface Box
You can operate this unit from the vehicle's control
1Press the PWR (Power) button at least 3
seconds to turn off the power.unit when an Alpine Remote Control Interface Box
(optional) is connected. For details, contact your
2Press the (Release) button at lower leftAlpine dealer.
corner until the front panel pops out.
3Grasp the left side of the front panel and pull it
out.Initial System Start-Up
Immediately after installing or applying power to the
unit, it should be initialized. Press the RESET switch
with a ballpoint pen or any other pointed object.
NOTES
" The front panel may become hot in normal usage
(especially the connector terminals), this is not
malfunction.
" To protect the front panel, place it in the supplied
carrying case.Turning Power On and Off
1Press the PWR (Power) button to turn on the
unit.
NOTE
The unit can be turned on by pressing any other button
except the eject c button.
Attaching the Front Panel
The volume level gradually increases to the previous
1First, insert the right side of the front panel intolevel you were listening to before the unit was turned
the main unit. Align the groove on the front paneloff. Press the PWR button for at least 3 seconds to
with the projections on the main unit.turn off the unit.
2Push the left side of the front panel until it locksNOTE
firmly into the main unit.The very first time the power is turned on, the volume
will start from level 12, the BBE will be on in the tuner
2mode.
11
NOTE
Before attaching the front panel, make sure that there is
no dirt or dust on the connector terminals and no foreign
object between the front panel and the main unit.
4-EN |
ACEC
