Installation and Connections
Before installing or connecting the unit, pleaseDO NOT INSTALL IN LOCATIONS WHICH MIGHT
read the following and pages 2 and 4 of this
HINDER VEHICLE OPERATION, SUCH AS THE
manual thoroughly for proper use.
STEERING WHEEL OR GEARSHIFT.
Doing so may obstruct forward vision or hamper
Warningmovement etc. and results in serious accident.
MAKE THE CORRECT CONNECTIONS.
Failure to make the proper connections may result in fire
Caution
or product damage.
HAVE THE WIRING AND INSTALLATION DONE BY
USE ONLY IN CARS WITH A 12 VOLT NEGATIVEEXPERTS.
GROUND.The wiring and installation of this unit requires special
(Check with your dealer if you are not sure.) Ftechnical skill and eailure to doxperience. To ensure safety, always
so may result in fire, etc.contact the dealer where you purchased this product to
have the work done.
BEFORE WIRING, DISCONNECT THE CABLE FROM
THE NEGATIVE BATTERY TERMINAL.USE SPECIFIED ACCESSORY PARTS AND INSTALL
Failure to do so may result in electric shock or injury dueTHEM SECURELY.
to electrical shorts.Be sure to use only the specified accessory parts. Use of
other than designated parts may damage this unit
DO NOT ALLOW CABLES TO BECOME ENTANGLED
internally or may not securely install the unit in place.
IN SURROUNDING OBJECTS.This may cause parts to become loose resulting in hazards
Arrange wiring and cables in compliance with the manual
or product failure.
to prevent obstructions when driving. Cables or wiring
that obstruct or hang up on places such as the steeringARRANGE THE WIRING SO IT IS NOT CRIMPED OR
wheel, gear lever, brake pedals, etc. can be ePINCHED BY A SHARP METxtremelyAL EDGE.
hazardous.Route the cables and wiring away from moving parts (like
the seat rails) or sharp or pointed edges. This will prevent
DO NOT SPLICE INTO ELECTRICAL CABLES.
crimping and damage to the wiring. If wiring passes
Never cut away cable insulation to supply power to otherthrough a hole in metal, use a rubber grommet to prevent
equipment. Doing so will exceed the current carryingthe wire's insulation from being cut by the metal edge of
capacity of the wire and result in fire or electric shock.
the hole.
DO NOT DAMAGE PIPE OR WIRING WHEN
DO NOT INSTALL IN LOCATIONS WITH HIGH
DRILLING HOLES.
MOISTURE OR DUST.
When drilling holes in the chassis for installation, takeAvoid installing the unit in locations with high incidence
precautions so as not to contact, damage or obstruct pipes,of moisture or dust. Moisture or dust that penetrates into
fuel lines, tanks or electrical wiring. Failure to take such
this unit may result in product failure.
precautions may result in fire.
DO NOT USE BOLTS OR NUTS IN THE BRAKE OR
STEERING SYSTEMS TO MAKE GROUND
CONNECTIONS.
Bolts or nuts used for the brake or steering systems (or
any other safety-related system), or tanks should NEVER
be used for installations or ground connections. Using
such parts could disable control of the vehicle and cause
fire etc.
KEEP SMALL OBJECTS SUCH AS BATTERIES OUT
OF THE REACH OF CHILDREN.
Swallowing them may result in serious injury. If
swallowed, consult a physician immediately.
37-EN |
ACEC
