CD-BA1200H
OPERATION MANUAL
Replace the batteries if the operating distance is reduced or if the operation becomes erratic. Periodically clean the transmitter LED on the remote con- trol and the sensor on the main unit with a soft cloth. Exposing the sensor on the main unit to strong light may interfere with operation. Change the lighting or the direc- tion of the unit. Keep the remote control away from moisture, excessive heat, shock, and vibrations.To erase all of the stored memory contents (clock and timer settings, and tuner and CD presets). If the display is not correct. If the operation is not correct.Press the ON/STAND-BY button to enter the stand- by mode.Whilst pressing down the / button and the EQUALIZER/X-BASS/DEMO button, hold down the ON/STAND-BY button for at least 1 second. "CLEAR AL" will appear.The operation explained above will erase all data stored in memory including clock and timer settings, and tuner and CD presets.
Notes concerning use:Reset the microcomputer under the following condi- tions:12Caution:
EQUALIZER X-BASS/ DEMO
0.2 m - 6 m (8" - 20')
15
15
ON/ STAND-BY
REMOTE CONTROLRESETTING THE MICROCOMPUTER
Press the TUNING/TIME ( or ) button to adjust the hour.Press the TUNING/TIME ( or ) button once to advance the time by 1 hour. Hold it down to advance con- tinuously. When the 12-hour display is selected, "AM" will change automatically to "PM".Press the MEMORY/SET button.Press the TUNING/TIME ( or ) button to adjust the minutes.Press the TUNING/TIME ( or ) button once to advance the time by 1 minute. Hold it down to change the time in 5 - minute intervals. The hour setting will not advance even if minutes advance from "59" to "00".Press the MEMORY/SET button.The clock starts operating from "0" second. (Seconds are not displayed.) And then the clock display will disappear after a few seconds.The time display will appear for about 5 seconds.The clock display will flash on and off at the push of the CLOCK button when the AC power supply is restored after a power failure occurs or after the AC power lead is disconnected. If this happens, follow the procedure below to change the clock time.PUTER".
6789To see the time display: Press the CLOCK button.Note:To change the clock time: 1Press the CLOCK button. 2Within 5 seconds, press the MEMORY/SET button. 3Perform steps 6 - 9 above.To change the time display mode: 1Perform steps 1 - 2 in "RESETTING THE MICROCOM-2Perform steps 1 - 9 above.
(0:00 - 23:59)(AM 0:00 - PM 11:59)(AM 12:00 - PM 11:59)
AM 0:00
CLOCK
ON/ STAND-BY
MEMORY/SETTUNING/TIME ( )0:00 AM 12:00
Press the ON/STAND-BY button to enter the stand- by mode.Press the CLOCK button.Within 5 seconds, press the MEMORY/SET button.Press the TUNING/TIME ( or ) button to select the time display mode.Note that this can only be set when the unit is first installed or it has been reset."0:00"The 24-hour display will appear."AM 0:00"The 12-hour display will appear."AM 12:00"The 12-hour display will appear.Press the MEMORY/SET button.
SETTING THE CLOCK(Main unit operation)
In this example, the clock is set for the 24-hour (0:00) sys- tem.12345
� 6 � |
ACEC
