Basic Operation
INTLZPWR8
RESET
MODE1Preset buttons4c9
(1 through 6)
Detaching the Front Panel? Controlable with Remote Control
This unit can be controlled with an optional
1Press the PWR (Power) button for more than 3
Alpine remote control. For details, consult your
seconds to turn off the power.
Alpine dealer.
2Press the (Release) button at lower left? Connectable to Remote Control Interface
corner until the front panel pops out.Box
You can operate this unit from the vehicle's
3Grasp the left side of the front panel and pull it
out.control unit when an Alpine Remote Control
Interface Box (optional) is connected. For
details, contact your Alpine dealer.
NOTESInitial System Start-Up
? The front panel may become hot in normal usage
(especially the connector terminals), this is not
Immediately after installing or applying power to the
malfunction.
unit, it should be initialized. Press the RESET
? To protect the front panel, place it in the supplied
carrying case.switch with a ballpoint pen or any other pointed
object.
Attaching the Front PanelTurning Power On and Off
1First, insert the right side of the front panel into1Press the PWR (Power) button to turn on the
the main unit. Align the groove on the front panelunit.
with the projections on the main unit.
NOTE
The unit can be turned on by pressing any other button
2Push the left side of the front panel until it locks
firmly into the main unit.except the eject c button.
The volume level gradually increases to the previous
2level you were listening to before the unit was turned
off. Press the PWR button for more than 3 seconds
11
to turn off the unit.
NOTE
The very first time the power is turned on, the volume
NOTEwill start from level 12, the BBE will be on in the tuner
Before attaching the front panel, make sure that thermode.e is
no dirt or dust on the connector terminals and no
foreign object between the front panel and the main
unit.
4-EN |
ACEC
