Basic Operation
Attaching the Front Panel
OPEN/CLOSE1First, insert the right side of the front panel into
the main unit. Align the groove on the front panel
with the projections on the main unit.
2Push the left side of the front panel until it locks
firmly into the main unit.
2
11
NOTE
Before attaching the front panel, make sure that there is
no dirt or dust on the connector terminals and no foreign
object between the front panel and the main unit.
SOURCE/POWER
[Compatibility with Factory Steering Wheel
Radio Controls
Detaching the Front PanelIf your vehicle has steering wheel controls for the
radio, an optional steering wheel control
interface may be available to connect your Alpine
1Press and hold SOURCE/POWER for more than
radio. For details, contact your Alpine dealer.
2 seconds to turn off the power.[Controllable with Remote Control
2Press (Release) at lower left side until theThis unit can be controlled with an optional
Alpine remote control. For details, consult your
front panel pops out.
Alpine dealer.
Point the optional remote control transmitter at
3Grasp the left side of the front panel and pull it
out.the remote control sensor.
Remote controlRemote control
sensorsensor
NOTES
? The front panel may become hot in normal usage
(especially the connector terminals), this is not a
malfunction.
When the monitorWhen the monitor
? To protect the front panel, place it in the suppliedis open.is closed.
carrying case.
Y You can use the remote control even when the
monitor display is closed.
[CVA-1014R/CVA-1014RB/CVA-1014RR is not
compatible with MD, cassette tapes and a 3-
disc changer.
Initial System Start-Up
Immediately after installing or applying power to the
unit, it should be initialized. To do this, first, remove
the detachable front panel. Behind the front panel, to
the right of the connector, there is a small hole.
Using a pencil or other pointed object, press the
Reset switch mounted behind this hole to complete
the initialization procedure.
RESET switch
6-EN |