BA-210SPBassamp Cube with Digital Effects
PROGRAMMING THE FOOTSWITCH:
The BA-210SP allows you to save four DSP settings by means of the two button footswitch sup-
plied with the amplifier. Use the following steps to sts e t t i n g s :ore and recall four DSP
YPress the footswitch button until both LEDs are off � select an effect (bypass, O0�) � for reference,
this shall be Preset A
YPress the #1 button on the footswitch (the #1 LED illuminates and Preset A is stored) - select
another effect (chorus, O1�) and adjust to taste � for reference, this shall be Preset B
YPress the #2 button on the footswitch (the #2 LED illuminates and Preset B is stored) - select
another effect (octawah, O11�) and adjust to taste � for reference, this shall be Preset C
YPress the #1 button on the footswitch again (the #1 LED turns off and Preset B is stored) - select
another effect (SVT, O12�) and adjust to taste � for reference, this shall be Preset D
YPress the #2 button on the footswitch again (both LEDs are off and Preset D is stored) - Preset A
is automatically recalled � without changing the setting of the Effects control. Selection of the
e ffects is now controlled by the footswitch.
NOTE: The footswitch presets will be retained within the amplifier even after turning the amplifier
off, until the above steps are repeated using different effects settings.
Preset APreset B
Preset CPreset D
SYSTEM BLOCK DIAGRAM:
7 |
ACEC
