TROUBLESHOOTING GUIDE
What to do when the safety system is c) Electrical module fault.
activatedThe ?Speed? indicator ?anStartd Delay? option
The programme is interrupted, an audible tone (depends on model) flashes. The display shows
sounds and various indicators point to ?tF4he source to F1?,6
of the fault. Press th?Start/Pause ? ebutton once again.
Fault description .tableThe programme will continue.
If the fault re-occurs, contact After-Sales
Small lamp Digital AudibleFault
Service (see ?After-Sales Service?).
lights updisplay tonedescription
?Water tap?H30 sec Water inlet fault
d) Waterstop fault.
-P30 sec Draining out
An audible tone sounds. The light of the
faultwaterstop indication is on. The display
-4 to 16 30 secElectrical alternately shows ?A? and ?F?. Switch off the
module faultappliance by turning the programme selector to
?Watersto?pA30 sec Waterstop faulthet position, unplug the appliance and make
sure that the water tap is closed.
a) Water inlet fault (no or insufficient
The Waterstop can be caused by
water supply).
1. Too much foam
The ?Water tap? indicator is on or the display
2. A leak in the inlet hose or in the appliance.
alternately shows?H? and ?F?. Switch off the
Lean carefully the appliance over onto its left side
appliance by turning the programme selector to
to allow the collected water to flow out.
the position and unplug it.
Next:
Check whether:
1. Connect the appliance to the electrical outlet,
the water tap is completely open, and the
2. Open water supply to was?her (if Start? button
water supply pressure is sufficient;
is not pressed, but washer begins to fill, close
the water inlet hose is kinked;
water supply and call After Sales Service),
the mesh filters are clogged (see
3. Reselect the desired programme and press
?Maintenance and Cleaning?/?Water Hose
the ?Star?t button (there is no need to add
Mesh Filters?);
the water inlet hose is frozen.additional detergent). The programme will
continue.
Connect the appliance to the electrical outlet,
If the fault occurs again, call After Sales Service
reselect the desired programme and press the
(with details about the ?fault, sAfter Saee les
?Start/Pau?s buttoen again to continue with the
Service?).
programme (do not add detergent for this
programme).Fault ?Waterstop? when the programme
selector is in the position
b) Draining out fault.
The appliance identifies a water leakage even
The display alternately?P ?s and hows?F ?. Switch
when the power to the washer is off.
off the appliance by turning the programme
An audible tone sounds. The display
selector to the position and unplug it.
alternately show?A? ans d ?F?.
Check whether:
The water leakage can be caused by a leak in
the drain hose is kinked (see Installation
the inlet hose or in the appliance.
Instructions);
Unplug the appliance and make sure that the water
the pump/ foreign body trap are blocked
tap is closed, lean the appliance over onto its left
(see ?Removing the Foreign Body Trap?);
side to allow the collected water to flow out.
IMPORTANT: Before draining, allow the wash
water to cool down.Call After-Sales Service (with details about the
fault, se?Afe ter-Sales Service?).
the drain hose is frozen.
Connect the appliance to the electrical outlet,
reselect the desired programme and press the
?Start/Pau?s buttoen again to continue with the
programme (do not add detergent for this
programme).
If the fault re-occurs, contact After-Sales Service
(see ?After-Sales Service?).
29 |
ACEC
