III. CARE AND CLEANING
GENERAL CARE OF THE APPLIANCE
Before cleaning the oven by hand, allow it to cool and make sure that all switches are
switched off.
Do not use abrasive powders or metal wool.
POLISHED, PAINTED OR ENAMELLED METAL SURFACES
Use cleaning agents sold specially for this purpose.
OVEN DOOR GLASS PANELS
After cooking dishes which cause fat splashing, it is recommended to remove any splashes
from the inside of the oven door glass panel using a non-abrasive cleaning agent sold special-
ly for the purpose.
Abrasive cleaning agents or hard kitchen scourers must not be used to clean the enamelled
metal surfaces of the oven door.
ROASTS
Use a sponge moistened with a cleaning agent sold for the purpose; do not use abrasive
powders or sharp objects.
BB
CARE TASKS
Removing the oven door
To remove the oven door, guide the
lever (A) into the hinge notch (B): close
the door to its stop position and pull
A
A
out towards you.
Refit in the reverse order.
J
Changing the oven light bulb
H
To change the bulb, remove the cover
(H). Proceed as shown in the diagram
opposite. Use only E14 - 15W - 300 !C
bulbs. Remember to replace the seal
(J).
39 |
ACEC
