54141 IFU INGLESE 12Y10Y2000 9:37 Pagina 8
Electrical connection
Y Make sure the appliance isY Do not use multiple plugis the same as the power
installed and connected toadapters or extensionsupply voltage in your
the electricity supply by aleads.home.
qualified technician inY After the oven has beenThe service number is
accordance with theinstalled, the electricallocated on the front edge
manufacturer's instructionscomponents must beof the oven cavity (visible
and in compliance withconcealed.when the oven door is
local regulations.open).
Y The installer is responsibleWARNING: DO NOTY Use a type H05RR-F power
for the correct electricalCONNECT TO THE POWERcord (minum length: 800
connection of theSUPPLY BEFORE YOU HAVEmm).
appliances and theFINISHED CONNECTING THE
observance of the relativeOVEN AND THE COOKTOP
safety recommendations.Y Mount the oven in the
Y The appliance must bekitchen unit. Make sure
connected to the electricitythe power cord is not
supply by means of an all-entrapped.
pole disconnect switch
with minimum contact gapConnecting the oven to
of 3 mm.the power supply
Y The appliances must beY Make sure that the voltage
earthed by law.shown on the rating plate
400V 3~400V 2 ~
N L1 L2 L3N L1 L2 L3
Conductors x numbersConnectionT S RSR
E400VE
2 + ~HO5 RR-F 3 x 4 mmq400V400V
ETSRESR
3 +~HO5 RR-F 4 x 2,5 mmq
Interconnecting cooktophand side of the control
and ovenpanel, the 4 pole connector
Y Before connecting the(J) is located at the top of
oven to the power supply,the oven in the left hand
check that the cooktop iscorner (see figure).
among the ones listed inY Connect the yellow/green
the cooktop/oven pairingstriped earth wire () (K)
product sheet.from the cooktop to the
Y Connect the 3 pole and 4screw located near the 3
pole connectors to thepole connector.
respective connectors on
the oven.
The 3 pole connectors (H) is
located at the rear right |
ACEC
