Electrical connection
Y Make sure the appliance isY Do not use multiple plugis the same as the power
installed and connected toadapters or extensionsupply voltage in your
the electricity supply by aleads.home.
qualified technician inY After the oven has beenThe service number is
accordance with theinstalled, the electricallocated on the front edge
manufacturer's instructionscomponents must beof the oven cavity (visible
and in compliance withconcealed.when the oven door is
local regulations.open).
Y The installer is responsibleWARNING: DO NOTY Use a type H05RR-F power
for the correct electricalCONNECT TO THE POWERcord (minum length:
connection of theSUPPLY BEFORE YOU HAVE800 mm).
appliances and theFINISHED CONNECTING THE
observance of the relativeOVEN AND THE COOKTOP
safety recommendations.Y Mount the oven in the
Y The appliance must bekitchen unit. Make sure
connected to the electricitythe power cord is not
supply by means of an all-entrapped.
pole disconnect switch
with minimum contact gapConnecting the oven to
of 3 mm.the power supply
Y The appliances must beY Make sure that the voltage
earthed by law.shown on the rating plate 400V 3N~230V 1N~
N L1 L2 L3N L1 L2 L3
N TS RNR
E230VE
Conductors x numbersConnection230V
230V230V
E N T SRE N R
2
1N+~HO5 RR-F 3 x 4 mm
400V 2N~230V 3 ~2
2N+~HO5 RR-F 4 x 2,5 mmN L1 L2 L3N L1 L2 L3
N SRN SR
2E230V230VE230V230V
3 +~HO5 RR-F 4 x 2,5 mm
230V230V
E N S RE T S R
2
3N+~HO5 RR-F 5 x 1,5 mm
Interconnecting cooktopThe 3 pole connectors (H) is
and ovenlocated at the rear right
Y Before connecting thehand side of the control
oven to the power supply,panel, the 4 pole connector
check that the cooktop is(J) is located at the top of
among the ones listed inthe oven in the left hand
the cooktop/oven pairingcorner (see figure).
product sheet.Y Connect the yellow/green
Y Connect the 3 pole and 4striped earth wire () (K)
pole connectors to thefrom the cooktop to the
respective connectors onscrew located near the 3
the oven. pole connector. |
ACEC
