Installation
Technical information
for the installer
Oven
Y Unpack the oven to make
the connections. Rest the
oven on the polystyrene
base to avoid damaging it.
Y Do not lift the oven by the
door handle, but hold it at
the sides by means of the
side handles.
Y Make sure that the
appliance has not been
damaged during transport.
Y The dimensions of the
oven and the unit are
given in the picture at the
side.Y To ensure correct
Y Units in contact with theventilation, respect the
oven must be heatventilation openings
resistant (90!C).indicated in the picture
2
Y If plastic laminates or the(200 cmminimum).
sealing material are notThere must be a gap of at
sufficiently heat resistant,least 5 mm between the
bubbles may form, theupper edge of the oven
surface may be deformedand the lower edge of the
or the coating may detach.working surface. This gap
must never be closed by
strips or unit reinforcing
pieces.
Y Make the electrical
connection between hob
and oven (see OElectrical
connection�).
Y Fasten the oven to the unit
with the two screws (A) as
shown. |
ACEC
