496gb94500.fm5 Page 15 Wednesday, July 4, 2001 11:19 AM
How to fill the salt container
From a water hardness 2. As soon as the required water
category of 1, before using hardness level is reached, press the
the dishwasher for the first On/Off button.
time, fill the salt container System 3:
with regeneration salt (to 1. Press and hold the Start button
find out the hardness level of and simultaneously turn the
water in your area, contact programme dial one position to
your local Water Board or the left.
check the last bill you 2. Release the Start button (the salt
received).level indicator will flash and the
If the water hardness level setting value 2 will be displayed).
does not correspond to To change the set value: press the
position 2 on the selector Start button until the required
(setting on delivery) or if the value is reached.
water hardness level 3. When the required water
changes, set the correct hardness level is reached and the
water hardness level on the indicator lamps light up, as shown
salt container cap or in the table, turn the programme
(according to the model) dial to the ?Off? position.
using system 2 or 3.Table of water hardness
System 2:
categories:
1. Press and hold the
programme select button
and the On/Off button (the
salt level indicator lamp will
flash and the indicator lamp
e will light up). To
change the set value: press
and hold the programme
select button until the
required value is reached.
Table of water hardness categories:
System 1
°dH°fH°Clarkemmol/lHardness
category
0-60-110-80-1.10
7-1112-169-111.2-2.01
12-1617-2912-202.1-2.92
17-2130-3721-263.0-3.73
22-3538-6227-443.8-6.24
System 2 and 3
Hardness
°dH°fH°Clarkemmol/lIndicator Lights
category
0-60-110-80-1.10no indicator light on
7-1612-299-201.2-2.91
/
17-2130-3721-263.0-3.72
/
22-3538-6027-443.8-6.23
/
15 |
ACEC
