90031 gb.fm5 Page 1 Tuesday, September 25, 2001 11:15 AM
GBPROGRAMME CHARTGSI 4751
Important:
?If a fault occurs or you wish to change the current programme, press the
?START? button for about 5 seconds until the Start indicator lamp switches
off ! Refer to the ?Troubleshooting guide? in these user instructions to rem-
edy any problems.
?Sometimes even when the regeneration salt container is full, the corre-
sponding indicator lamp may illuminate during the first wash cycle.
?Switch off the dishwasher once the ?Start? indicator lamp has switched
off. If you switch off the dishwasher during a wash cycle, when switched
on again the dishwasher resumes the cycle from where it was interrupted.
On/Off button Rinse aid level indicator Eco-Dry
Add rinse aidDry cycle without using fans.
Start
Start button indicator lamp:
Switches ?on? when the dishwasher is ope Saltrating. level indicator
Flashes when a f ault occurs.Add regeneration salt
Switches off at the end of the programme.
Programme progress indicator
Pre-rinse
Washing
Drying
Programme end
Detergent dispenser:Consumption ***
Final rinse Final rinse
+) with pre-rinse
temperature:temperature:Normal load
ProgrammeLoad -) without pre-rinse
symbolCrockery and cutlery** Small large
Water EnergyTime
compart-compart-
(Liter)(kWh)(Min.)
mentment
Crockery to be washed later.----5.00.029
Pre-rinse
Normally soiled crockery, with dried-on food. 65 °C-+12.5 65 °C1.3073
Bio-Eco 50 °C *
Normally or heavily soiled crockery with dried-on
65 °C++ 65 °C17.01.3585
Bio-Normale 50 °C * 1)food.
Normally or heavily soiled crockery. 65 °C++1 65 7.0 °C 1.5085
Normal 65 °C
Heavily soiled pans and saucepans. 65 °C++ 6521 .°5C1.7093
Intensive 70°C
*) Recommended programme for use with ?new generation? enzyme-based detergents.
**)For pre-rinse .
***)Values for normal conditions. Values may vary in relation to usage, e.g.: different loads, watnd poer wer tempsuerppatuly revos, ltagwatee.r hardness a
1) Check the programme on the energy data plate.
5019 100 90031 |
ACEC
