How to use the dishwasherUpper and lower rack
1. After loading the dishwasher, cl6.osOne tceh the e Start indicator lamp hCraocs kery holders:Lower rack
door properly and open the water switched off press the On/Off buttoDnown: to cups and long-stemmed
supply tap.switch the dishwasher o All theff. glasses.B
2. Press the On/Off button to switch indicthe ator lamps switch off.
dishwasher on.One o f the programme 7. Open the door (warning: beware of hot Up: plates.A
indicator lamps will switch on.steam). Unload the lower rack before
3. Select the desired programme by the upper one. Close the water tap.
pressing the corresponding button. Upper rack
The corresponding indicator lamp
lights uIfp. required, select optionsC
(if supplied).
4. Press the Start button to start the
selected programmThee. Start ?Vario Organizer? multi-purpose
support:Plate holders:
indicator lamp will light up Once s.et,
the programmed data cannot be To be used, for example, for long-May be lowered to increase
altered by pressing the programme handled utens (ailsrrange knives available spacA).e (
selector buttons.with the blade facing downwar ds),May be removed to increase
Note: Once the Start button has been cups and glasses.available spacB).e To (remove:
pressed, the dishwasher memorises the May be used in three different pull the handle up.
last programme selected. This positions (see also ?Dishwasher
information remains in the memory even loading instructions? on Page 4).B
during interruption of the power supply.1. Upon the left-hand side of the rack.A
To change the selected 2. Upside-down, towards the centre of
programme, press the Start button
for about 5 secountinds,l the the rack.
3. Upside-down, towards the left side.
Start indicator lamp switches
off. Select a new programme
using the programme selector
knob and press the Start button.Cutlery basket:
Note: If the dishwasher is switched off The cutlery basket can be removed to
during a wash programme, when increaseC () available space.
switched on again it will resume the
wash cycle from where it was
C
interrupted.Rack height adjustment:
Only open the dishwasher doo(The dishwasr if her is delivered with the upper
strictly necessary during a rack in the twash op position).Glass holder:
cycle and exercise maximum The rack height can also be changed
caution. Danger of scaldingwh froen lom aded.
steam.? To lower: pull o twut tho siede
5. To indicate the end of the programhmande, les and gently lower the rack.
the Start indicator lamp switches off To raise: pull uptwo the side handles
and the End indicator lamp (if fitted) until the rack clicks into place.
lights up (for about 30 mi. n.) The rack must be level on both
sides.
Please read the user instructions carefully. |
ACEC
