94017-gb.fm5 Page 21 Wednesday, September 26, 2001 6:15 PM
TROUBLESHOOTING GUIDE
If a fault occurs, before contacting our After-Sales Service, make the following
checks to try and remedy the problem.
Restart the wash programme to see if the Other fault signals depending on the model
fault repeats.installed:
? Press theStar buttotn for about 5 seconds The indicator lamp on the control panel
until the Start indicator lamp switches offflashes. to indicate that the water-stop
? Briefly press the Star buttont.system has tripped. Switch off the dishwasher,
disconnect the mains plug, turn off the water tap
If the malfunction persists, switch off the and contact our After-Sales Service.
appliance and turn off the water tap. Call our
After-Sales Service.
Crockery still dirty after washing:
The appliance will not switch on:? Have you selected the correct programme?
? Power plug properly inserted in the mains ? Have you used the correct amount of
socket?detergent?
? Power failure?? Filters clogged or incorrectly assembled?
? Have you switched the dishwasher on?? Spray arms blocked or nozzles clogged?
? Have you pressed the Start button?? Salt container cap screwed down?
? Have you set the delay timer (if fit?ted)?Crockery loaded correctly? (the water jets
must spray the entire surface of all items).
? Tap turned on? If not:
? Turn on the water tap.
Spotted crockery:
? Make sure the water hose filter is not ? Water hardness duly checked and
clogged.regulated?
To do this, turn off the water tap, disconnect ? Salt container empty?
the water hose, clean the filter, reconnect ? Insufficient detergent?
the water hose to the tap and turn on the tap.
? Filters clogged?Spotted glasses and cutlery:
Crockery loaded upside down? ? Too much rinse aid? (Adjust the rinse aid
When loading large items in particular, make
sure the water circulates and does not collect regulator to a lower setting).
Note:
inside them.
? Door closed properly?On some models when the Star but tton is
pressed, a pre-rinse cycle is performed prior to
? Fault indicated?the actual wash programme to regenerate the
The Start indicator lamp or indicator lwater softamp ener system.
F1...F9 flashes (depending on the model
installed), if a fault is detected. F9 flashes
(depending on the model installed), if a fault
is detected.
AFTER-SALES SERVICE
Before contacting our After-Sales (the number after the
Service:word Service on the
adhesive label) located
1. try to remedy the problem
inside the door on the
(see ?Troubleshooting guide?).right hand side.
2. Switch off the dishwasher and restart the
wash programme to see if the fault repeats.
If, after carrying out the above checks the
malfunction persists, call our After-Sales
Service and specify:? your name, address and telephone number.
? the nature of the problem.
? the appliance type and model.
? the service number
21 |
ACEC
