94023-gb.fm5 Page 18 Wednesday, September 26, 2001 6:24 PM
CONNECTIONS
Refer to the separate installation instructions Electrical connections:
booklet.? Closely adhere to local Electricity Board
Water inlet and drain:regulations.
? Strictly follow local Water Board regula? Voltations.ge information is shown on the rating
? Make sure the inlet and drain hoses are plate mounkink-ted inside the door on the right
free and are not crushed.hand side.
? If the hose length does not suffice, replace ? The appliance must be earthed as prescribed
with similar hoses obtained from your locaby law.l
dealer or our After-Sales Service.? Do not use extension leads or multiple
? The inlet hose must be securely clamped toadapters et c.
the water tap to prevent leaks.? Before carrying out maintenance, disconnect
? The inlet water temperature varies according the mains plug.
to the model installed: inlet hose marked ? Do not use the dishwasher if it has been
?25°C max.?: maximum temperature 25°C. damaged in transit. Consult your local retailer
All other models: maximum temperature or our After-Sales Service.
60°C.? The power cable must only be replaced by a
? When installing the appliance, make sure qualifiethe d technician.
drain water discharges correctly and, if
necessary, remove the wire gauze from the
sink siphon.
? Secure the drain hose with a clamp to the
siphon to prevent it from dropping off during
operation.
? For appliances with water-stop system only:
if the water connections are made correctly,
the water-stop system safeguards your home
against damage caused by flooding.
18 |
ACEC
