94023-gb.fm5 Page 21 Wednesday, September 26, 2001 6:24 PM
TROUBLESHOOTING GUIDE
If a fault occurs, before contacting our After-Sales Service, make the following
checks to try and remedy the problem.
Restart the wash programme to see if the End
Other fault signals depending
fault repeats.
on the model installed.
? Press theStar buttotn for about 5 seconds
The programme progress indicator lamp on
until the Start indicator lamp switches off.
the control panel flashes:
? Briefly press the Star buttont.
Detach the lower spray arm. Check crockery and
If the malfunction persists, switch off the
cutlery have been loaded correctly and that the
appliance and turn off the water tap. Call our
lower spray arm has been correctly fitted.
After-Sales Service.
Crockery still dirty after washing:
The appliance will not switch on:
? Have you selected the correct programme?
? Power plug properly inserted in the mains
socket?? Have you used the correct amount of
detergent?
? Power failure?
? Filters clogged or incorrectly assembled?
? Have you switched the dishwasher on?
? Spray arms blocked or nozzles clogged?
? Have you pressed the Start button?
? Salt container cap screwed down?
? Have you set the delay timer (if fitted)?
? Crockery loaded correctly? (the water jets
? Tap turned on? If not:
must spray the entire surface of all items).
? Turn on the water tap.
? Make sure the water hose filter is notSpott ed crockery:
clogged.? Water hardness duly checked and regulated?
To do this, turn off the water tap, disconnect? Salt container empty?
the water hose, clean the filter, reconnect
? Insufficient detergent?
the water hose to the tap and turn on the tap.
? Filters clogged?Spotted glasses and cutlery:
Crockery loaded upside down? ? Too much rinse aid? (Adjust the rinse aid
When loading large items in particular, make regulator to a lower setting).
sure the water circulates and does not collect
Note:
inside them.
On some models when the Star but tton is
? Door closed properly?
pressed, a pre-rinse cycle is performed prior to
? Fault indicated?the actual wash programme to regenerate the
The Start indicator lamp flashes:water softener system.
AFTER-SALES SERVICE
Before contacting our After-Sales If, after carrying out the
Service:above checks the
malfunction persists,
1. try to remedy the problem
call our After-Sales
(see ?Troubleshooting guide?).
Service and specify:
2. Switch off the dishwasher and restart the
? the nature of the
wash programme to see if the fault repeats.
problem,
? the appliance type and
model,
? the service number (the number after the
word Service on the adhesive label) located
inside the door on the right hand side,
? your name, address and telephone number.
21 |
ACEC
