Rainandindshieldsforplacingoeropeningss getting in. downwards to prevent any rain water and wind from door or window. Fit a suitable shield or point the hose Connect the other end of the hose to an opening in aplace a small container below it (see OA� in the picture). hole (dia. 3 mm) in the lowest point of the hose and to back into the tumble dryer, it is advisable to drill a small To prevent this water from Iying in the hose or flowing hose. low, the moisture might condense to water inside the Advice:function. disturb neighbours and could cause the dryer to mal- charge pipe or duct, as this could be dangerous, might Never connect the air vent hose into an existing dis- The unused outlet vent(s) must be covered. the collar supplied. appliance connected to one of the air outlet vents with cial 100 mm diametre flexible hose supplied with the vent hose to the outside of the building. Use the spe- The best way of evacuating the moisture is through aare unobstructed. 150 m The capacity of the venting circuit must be at leastopen door or window is enough. have ventilation towards the outside; generally, an there is very little humidity. Otherwise, the room must Normally, absorption is only possible in houses where the house must be able to easily absorb this moisture. The appliance expels hot, very moist air. The rest of the following precautions are taken. The appliance may be placed in any room, providedPositioningINSTALLATION
P0751
This is an unavoidable natural phenomenon.3
/hour. Check that the air inlet and outlet vents
If the hose is long and the room temperature
A
Condensation discharge at the backing as follows: Fit the collar into the required vent outlet by proceed-The vent hose collar is placed in the rear vent outlet. right side outlet. vent outlet provided at the back or through the front or Condensation may be discharged either through aCondensation discharge through a vent hoseouts with which the machine is fitted may operate. If the hose is completely squashed, the safety cut-higher energy consumption. be reduced, resulting in longer drying times and hose is partially squashed, drying efficiency will sure that the vent hose is not squashed. If the If the dryer is fitted next to kitchen units, makeP0060P0466
vent outlet. the collar firmly into the Push the vent hose withtight. to the vent hose until outlet. Attach the collar pulling it out of the vent Remove the collar by |
ACEC
