Operating Sequence6. Start the programme
Depress the ON/OFF push-
1. Check that the filters are cleanbutton.
(see cleaning instructions)
The pilot light will illuminate
and the machine will start.
2. Check that there is rinse aid
3. Load the dishesSO04
Remove any scraps of food.If you wish to interrupt the wash at any time press but-
ton again. To restart the machine, depress the same
Pull the lower basket out and arrange the saucepans,
button again and the programme will continue from
plates and cutlery in it.the point where it was interrupted.
Pull the upper basket out and arrange the plates,
saucers, glasses and cups etc. in it7. End of the washing programme
Slide the baskets back into the machine.At the end of the washing programme the Marker on
the knob will correspond with the Marker on the con-
Ensure that the spray arms can rotate freely.
trol panel
The machine will stop and the pilot light remains on
4. Measure out detergentuntil ON/OFF button is depressed.
Pour the required amount of detergent into the disTurn off the water tap. -
penser according to the indications in the Washing
Open the door and wait a few minutes before
Programmes chart and close the lid.
removing the dishes;in this way they will be cooler
Close the dishwasher door. and drying will be improved.
Empty the lower basket first and then the upper one;
5. Set the programmethis will avoid water dripping from the upper basket
onto the dishes in the lower one.
Turn the Programme Selector Dial clockwise until the
letter of the programme you wish to select corre-
sponds with the Marker on the control panel. Caution
In general it is not advisable to open the door while the
machine is working; if the door is opened however, a
safety device ensures that the machine stops.
If you have to open the door while the machine is AD
B
Cworking, always switch off the appliance first by press-
ing the ON/OFF button.
Do not open the door during the hot phases:
S023this may cause hot water escape.
PSO21GB
11 |
ACEC
