Adjusting the worktop
You can move the worktop forward or backward by
25 mm in order to align the machine with other
kitchen units.
Simply unscrew the two rear retaining screws,
move the top to the required position and then
retighten the screws.
Fitting under a counterIN03
(kitchen worktop or sink)
By removing the machineOs worktop, you can install
it under a close fitting sink unit or a pre-existing
570
¸
top, providing the dimensions of the recess600
correspond to those shown in the picture.
Proceed as follows:
820
Remove the machineOs worktop by unscrewing the
600
two rear retaining screws, pull from the front and
slide out the rear slots, lifting the worktop.
Insert the machine after adjusting the height andIN05
levelling with the adjustable feet. When inserting
the machine, ensure that the water inlet and drain
hoses are not kinked or squashed.
Levelling
Good levelling is essential for correct closure and
sealing of the door.
When the appliance is correctly levelled, the door
will not catch on the levelling spacers, either side of
the cabinet.
If the door does not close correctly, loosen or
tighten the adjustable feet until the machine is
perfectly level.
20PFI38GB |
ACEC
