DISPLAY COLOUR
Selecting the colour of theSetting the colour of the
display illumination using thedisplay illumination
colour scan (Syracuse /(Key West MP35)
Monterrey MP35)You can adjust the colour of the display
You can select the colour of the displayillumination to suit the illumination of
illumination during the colour scan. your vehicle cockpit. TheThe primary col-
display shows all the possible colourours red and green (R-G) are available
variations that are available in the RGBfor this.
spectrum. The colour scan takes ap-
prox. 40 seconds.Setting a colour for the display
illumination
?Press the MENU button 7.
?Press the MENU button 7.
?Press the or button 6
repeatedly until OCOL SCAN�?Press the or button 6 repeat-
appears in the display.edly until ODISP COL� appears in
the display.
?Press the or button 6.
The colour scan starts. All the possible?Press the or button 6.
colour variations that are available in theThe menu for mixing your own colour is
RGB spectrum are shown in the displaydisplayed. OR� and OG� are displayed
one after another.with the current values (0 to 4). The OR�
setting flashes.
If you want to select the display illumi-
nation colour that is currently being?Press the or button 6 repeat-
shown,edly until the setting that you want
is displayed after OR�.
?press the MENU button 7.
The settings are saved.?Press the or button 6 to
move the selection cursor to the
If you want to cancel the colour scan
without setting a new colour,position after the other colour (OG�).
?Adjust the other colour to suit your
?press the or button 6.preferences.
Note:When you have finished making your
IIf you do not press a button, thechanges,
colour scan will stop after cycling
through the colours once (approx.?press the MENU button 7 twice.
40 seconds) and the previouslyThe settings are saved.
selected colour will be applied as
the setting again.
26 |
ACEC
