FCC WARNINGPrecautionsHandling the Front Panel
This equipment has been tested and found to comply with theY Avoid installing the unit where it would be subject to high
Attaching the Front Panel
limits for a Class B device, pursuant to Part 15 of the FCCtemperatures, such as in direct sunlight or a hot air stream
Rules. These limits are designed to provide reasonable pro-from the heater, or where it would be subject to dust, dirt, orPlace the right hand side of the front panel so that the parts
tection against harmful interference in a residential installa-excessive vibration.A of the front panel are engaged with the parts B of the unit
tion. This equipment generates, uses, and can radiate radioY Do not turn on the unit if the temperature inside the car isas shown below. Then push the left hand side of the front
frequency energy, and, if not installed and used in accord-very high. Always cool down the unit before usage. Parkingpanel until it is securely locked.
ance with instructions, may cause harmful interference withyour car in direct sunlight will result in a temperature rise.
radio communications. However, there is no guarantee thatY If the unit does not turn on, check the connections first. ThenENGLISH
radio interference will not occur in particular installation. Ifcheck whether the fuse at the back of the unit is blown.Detaching the Front Panel
this equipment does cause harmful interference to radio orY Carefully read this manual before using the unit. If you en-
television reception, which can be determined by turning thecounter any problems that are not covered in this manual,Remove the CD from the unit, if any, and turn off the power of
equipment off and on, the user is encouraged to consult theplease consult the dealer where you purchased the unit orthe unit.
dealer or an experienced radio/TV technician for help.the dealer nearest to you.Press the REL to unlock the front panel from the unit. Grasp
You are cautioned that any changes or modifications not ex-Y This unit has been designed specifically for playback ofthe front panel as shown below and remove it from the unit.
pressly approved in this manual could void your authority tocompact discs bearing the following mark. Other discs can-
operate this equipment.
not be played.
Features
Handling Compact Discs
Y Detachable front panel
Y Be careful when removing a compact disk after the play-
Y Built-in power amplifier
back is completed because the disk may be extremely hot.
BPV 655Y Do not use non-conventional discs such as heart-shaped,Security
(max. output : 55W � 4ch)octangonal discs, etc. The player could be damaged.To avoid theft or loss of the front panel, you can inactivate
Y Do not expose compact discs to direct sunlight or any heatthe release button REL by installing the screw provided.
BPV 650source.
1.Unscrew the bolt marked at the left front side of the
(max. output : 50W � 4ch)Y Check all compact discs before playing, and discard*
cracked, scratched or warped discs.unit. (See diagram above)
Y FM/AM PLL Synthesizer tuner
Y Wipe dirty or damp discs outward from the centre with a2.Attach the front panel.
Y 30 Station preset memorysoft cloth.
3.Select a locking screw from the mounting hardware (See
Y Do not use any solvents such as commercially available
Y Travel Store / Scan tuningcleaners, antistatic spray, or thinner to clean the compactpage 7) and screw it into the same hole to fasten the front
discs.panel.
Notes
Y Do not press hard on the front panel when affixing it to the
unit. No more than light to moderate pressure should be
needed.
Y Make sure there is no dust or dirt on the electrical terminals
on the back of the front panel as this could cause intermitent
operation or other malfunctions.
E-1
BPV655(EN)_body12002.06.17, 14:33 |
ACEC
