Power Tool Safety Rules
Read and understand all instructions. Failure to follow all instructions listed
!WARNING
below, may result in electric shock, fire and/or serious personal injury.
SAVE THESE INSTRUCTIONS
Work AreaDo not abuse the cord. Never use the
Keep your work area clean and well lit.cord to carry the tools or pull the plug
Cluttered benches and dark areas invitefrom an outlet. Keep cord away from
accidents.heat, oil, sharp edges or moving parts.
Replace damaged cords immediately.
Do not operate power tools in explosiveDamaged cords increase the risk of electric
atmospheres, such as in the presence ofshock.
flammable liquids, gases, or dust. Power
When operating a power tool outside, use
tools create sparks which may ignite the
dust or fumes.an outdoor extension cord marked "W-A"
or "W." These cords are rated for outdoor
Keep by-standers, children, and visitorsuse and reduce the risk of electric shock.
away while operating a power tool.Refer to ORecommended sizes of Extension
Distractions can cause you to lose control.Cords� in the Accessory section of this
manual.
Electrical Safety
Grounded tools must be plugged into anPersonal Safety
outlet properly installed and grounded inStay alert, watch what you are doing and
accordance with all codes anduse common sense when operating a
ordinances. Never remove the groundingpower tool. Do not use tool while tired or
prong or modify the plug in any way. Dounder the influence of drugs, alcohol, or
not use any adaptor plugs. Check with amedication. A moment of inattention while
qualified electrician if you are in doubt asoperating power tools may result in serious
to whether the outlet is properlypersonal injury.
grounded. If the tools should electricallyDress properly. Do not wear loose
malfunction or break down, grounding
clothing or jewelry. Contain long hair.
provides a low resistance path to carryKeep your hair, clothing, and gloves away
electricity away from the user. Improperfrom moving parts. Loose clothes, jewelry,
grounding can shock, burn or electrocute.or long hair can be caught in moving parts.
Grounded tools are equipped with three
Keep handles dry, clean and free from oil
conductor cord and three prong type plugs.and grease.
Before plugging in the tool be certain the
Avoid accidental starting. Be sure switch
outlet voltage supplied is within the voltage
marked on the nameplate. Do not use OACis OOFF� before plugging in. Carrying tools
only� rated tools with a DC power supply.with your finger on the switch or plugging in
tools that have the switch OON� invites
Avoid body contact with groundedaccidents.
surfaces such as pipes, radiators, ranges
Remove adjusting keys or wrenches
and refrigerators. There is an increased
risk of electric shock if your body isbefore turning the tool OON�. A wrench or
a key that is left attached to a rotating part of
grounded. If operating the power tool in
damp locations is unavoidable, a Groundthe tool may result in personal injury.
Fault Circuit Interrupter must be used toDo not overreach. Keep proper footing
supply the power to your tool. ElectricianOsand balance at all times. Proper footing
rubber gloves and footwear will furtherand balance enables better control of the
enhance your personal safety.tool in unexpected situations.
Don't expose power tools to rain or wetUse safety equipment. Always wear eye
conditions. Water entering a power tool willprotection. Dust mask, non-skid safety
increase the risk of electric shock.shoes, hard hat, or hearing protection must
be used for appropriate conditions.
-2- |
ACEC
