BM 1609929B61 3/03 3/12/03 10:48 AM Page 3
Do not force tool. Use the correct tool foroperation. If damaged, have the tool
your application. The correct tool will do theserviced before using. Many accidents are
job better and safer at the rate for which it iscaused by poorly maintained tools. Develop a
designed.periodic maintenance schedule for your tool.
Do not use tool if switch does not turn itUse only accessories that are recom-
OON� or OOFF�. Any tool that cannot bemended by the manufacturer for your
controlled with the switch is dangerous andmodel. Accessories that may be suitable for
must be repaired.one tool, may become hazardous when used
on another tool.
Disconnect the plug from the power source
before making any adjustments, changing
accessories, or storing the tool. SuchService
Tool service must be performed only by
preventive safety measures reduce the risk of
starting the tool accidentally.qualified repair personnel. Service or
maintenance performed by unqualified
Store idle tools out of reach of children andpersonnel could result in a risk of injury. For
other untrained persons. Tools areexample: internal wires may be misplaced or
dangerous in the hands of untrained users.
pinched, safety guard return springs may be
Maintain tools with care. Keep cutting toolsimproperly mounted.
sharp and clean. Properly maintained tools,When servicing a tool, use only identical
with sharp cutting edges are less likely to bindreplacement parts. Follow instructions in
and are easier to control. Any alteration orthe Maintenance section of this manual.
modification is a misuse and may result in a
Use of unauthorized parts or failure to follow
dangerous condition.Maintenance Instructions may create a risk of
Check for misalignment or binding ofelectric shock or injury. Certain cleaning
moving parts, breakage of parts, and anyagents such as gasoline, carbon tetrachloride,
other condition that may affect the toolsammonia, etc. may damage plastic parts.
Angle Grinder Safety Rules
Always use proper guard with grindinghandle could cause loss of control of the
wheel. A guard protects operator fromgrinder, resulting in possible serious
broken wheel fragments. When usingpersonal injury.
grinding wheel attachments, the guard must
Before using a grinder or installing a new
always be attached to the tool andwheel, inspect the grinding wheel for
positioned for maximum safety, so the least
amount of wheel is exposed from the sidechips and cracks. Remove bad wheels
immediately. Run the tool at no load for
the tool is being operated.
one minute, holding the tool in the
Accessories must be rated for at least thedirection away from people. Wheels with
speed recommended on the tool warningflaws will normally break apart during this
label. Wheels and other accessories runningtime.
over rated speed can fly apart and cause
Carefully handle both the tool and
injury. Grinding wheels or any other
accessory must have a maximum safeindividual grinding wheels to avoid
chipping or cracking. Install a new wheel
operating speed greater than the Ono load
RPM� marked on the toolOs nameplate.if tool is dropped while grinding. Do not
use a wheel that may be damaged.
Hold tool by insulated gripping surfacesFragments from a wheel that bursts during
when performing an operation where theoperation will fly away at great velocity
cutting tools may contact hidden wiringpossibly striking you or bystanders.
or its own cord. Contact with a Olive� wireDo not use grinding wheel that is larger
will make exposed metal parts of the tool
than the maximum recommended size for
Olive� and shock the operator.your tool, or worn down damaged wheels
Always use auxiliary handle for maximumfrom larger grinders. Wheels intended for
control over torque reaction or kick-back.large angle sander/grinders are not suitable
Operation of the grinder without the side
-3- |
ACEC
