BM 1609929A20 3/03 3/12/03 10:35 AM Page 7
Assembly
Sanding Accessories AssemblyWHEEL GUARD INSTALLATION
BACKING PADWheel guard must be
!WARNING
Before attaching a backingattached when using disc
!WARNING
pad be sure its maximumgrinding wheels. Always keep wheel guard
safe operating speed is not exceeded by thebetween you and your work while grinding.
nameplate speed of the tool.
To attach the wheel guard disconnect tool
Wheel guard may not befrom the power source, align wheel guard
!WARNING
used for most sandinglocating tab with key way on mounting
operations. Always reinstall wheel guardflange and slip guard onto mounting flange.
when converting back to grindingTwist into place, always keep the wheel
operations.guard between you and your work when
grinding. Tighten screw to secure wheel
TO INSTALL BACKING PAD AND
guard.
SANDING DISC
Disconnect tool from power source. Set theLOCK NUT AND BACKING FLANGE
tool on its top side (spindle up). Place theYour tool is equipped with a threaded
rubber backing pad onto the spindle shaft.spindle for mounting accessories. Always
Center the sanding disc on top of theuse the lock nut and backing flange that has
backing pad. Insert the lock nut through thesame thread size as spindle.
disc and thread onto the spindle as far as
Disc Grinding Wheel Assembly
you can with your fingers. Press in the
Disconnect tool from power source. Be sure
spindle lock, then tighten the backing pad
that wheel guard is in place for grinding.
securely with lock nut wrench.
When using spin-on grinding wheels, thread
TO REMOVE BACKING PAD AND
directly onto the spindle.
SANDING DISC
Disconnect tool from power source. UsingWhen using mounting wheels, thread
BACKING FLANGE onto spindle, then place
the lock nut wrench unscrew the nut from
GRINDING WHEEL on the spindle. Thread
the spindle, while holding spindle lock in.
on the lock nut and tighten nut using a lock
WIRE BRUSH ASSEMBLYnut wrench provided with adapter kit, while
Before assembling wire brush to this tool,holding the spindle lock in.
disconnect from the power source. WireTO REMOVE: Reverse procedure.
brushes are equipped with their own
threaded hub, simply thread on to spindle.
Be sure to seat against shoulder before
turning tool OON�.
MOUNTING
SPINDLE LOCK FLANGE
SPINDLE
WHEEL
GUARDLOCATING
TAB
SPINDLE
BACKING
FLANGE
RUBBER
BACKING
DISC
PAD
GRINDING
WHEEL
SANDING
DISCLOCK NUT
SPIN-ON
WIRE
SPIN-ON GRINDING
BRUSHLOCK NUT
WHEEL
-7- |
ACEC
