BM 1609929H55 1-05 1/5/05 3:17 AM Page 7
Sanding Assembly
BACKING PADWIRE BRUSH ASSEMBLY
Before attaching a backingBefore assembling wire brush to this tool,
!WARNING
pad be sure its maximumdisconnect from the power source. Wire
safe operating speed is not exceeded by thebrushes are equipped with their own
nameplate speed of the tool.threaded hub, simply thread on to spindle. Be
sure to seat against shoulder before turning
Wheel guard may not be
!WARNINGtool ON.
used for most sanding
operations. Always reinstall wheel guard
SPINDLE LOCK
when converting back to grinding operations.
TO INSTALL BACKING PAD AND
SANDING DISC
Disconnect tool from power source. Set theSPINDLE
tool on its top side (spindle up). Place the
rubber backing pad onto the spindle shaft.RUBBER
Center the sanding disc on top of the backingBACKING
pad. Insert the lock nut through the disc andPAD
thread onto the spindle as far as you can with
your fingers. Press in the spindle lock, then
tighten the backing pad securely with lock nut
wrench.
TO REMOVE BACKING PAD ANDSANDING
SANDING DISCDISC
Disconnect tool from power source. Using
the lock nut wrench unscrew the nut from theSPIN-ON
spindle, while holding spindle lock in.WIRE
BRUSHLOCK NUT
Grinding Assembly
WHEEL GUARD INSTALLATIONbumps on guard line up with the two notches
Use wheel guard with discon the spindle neck, and lift guard off the
!grinding wheels. Alwaysspindle neck.WARNING
close the latch to secure the guard. Keep the
guard between you and the wheel. Do not
direct guard opening toward your body.
The position of the guard can be adjusted to
accommodate the operation being performed.
MOUNTING
To attach wheel guard DISCONNECT toolFLANGE
from power source.
SPINDLE
Open guard release/lock latch and position
guard on spindle neck so that the two bumps
on guard, line up with the two notches on the
spindle neck.GUARD
RELEASE / LOCK
Rotate guard either direction to desiredLATCH
position, and close latch to secure guard in
place.BUMPS
TO REMOVE GUARD: Open guard
release/lock latch, rotate guard until the two
-7- |
ACEC
