Operating Instructions
TRIGGER SWITCH WITH OLOCK-ON� BUTTONIf the OLock-ON� button is continuously being
!WARNING
Your tool can be turned OON� or OOFF� by squeezing ordepressed, the trigger cannot be released.
releasing the trigger. Your tool is also equipped with "Lock-ON"
button, located on the left side of the trigger handle, that allowsFIG. 2
for continuous operation without holding the trigger. The OLock-
ON� is a convenience for long cutting operations.
"LOCK-ON" BUTTON
NOTE: Switch can accommodate a padlock with a shackle of
up to 3/16� in diameter (not provided with tool) to prevent
unauthorized use.
TO LOCK SWITCH ON: Squeeze trigger, depress button and
release trigger.
TO UNLOCK THE SWITCH: Squeeze trigger and release it
without depressing the OLock-ON� button.
TRIGGER SWITCH
To prevent serious personal injury, always disconnect the plug for the power source before changing wheels, or!WARNING
making any adjustments on the tool.
Removing and Installing Wheels
1. Raise wheel guard as shown in (Fig. 3), push in spindle lock4. Press in spindle lock and tighten hex bolt with the wrench
(Fig. 1), and loosen the hex head bolt in the center of abrasiveprovided (ATTENTION: DO NOT OVERTIGHTEN).
wheel by rotating counter-clockwise with the wrench provided.
Whenever replacing a wheel, always adjust the
2. Remove the hex head bolt, outside flange and abrasive wheeldepth stop bolt to prevent the wheel from!WARNING
(Fig. 3).cutting into the surface the tool is resting on. Failure to make this
adjustment may result in serious personal injury.
3. Carefully install the new abrasive wheel onto the spindle shaft
and replace outside flange and hex head bolt.
FIG. 3
SPINDLEWHEELABRASIVE
SHAFTGUARDWHEEL
INSIDERETAININGOUTSIDE
FLANGERINGFLANGE
DEPTH STOP
ADJUSTMENT BOLT
LOCK NUTSPACERADAPTER
(THINNER)(THICKER)
HEX HEAD
BOLT
-6- |
ACEC
