Installation
To avoid injury always observe thethe operational handle. Attempting to lift or
!WARNING
following:carry the tool by the power cord will damage the
insulation and the wire connections resulting in
Unplug electric cord. Before transporting the
electric shock or fire.
saw, rotate head assembly to 45! right miter,
lock into detent, pull the head assembly com-Observe the position of the saw. People
pletely forward toward you, tighten the slide railstanding behind it could be injured by thrown
lock knob and lock the head assembly in thedebris.
lowered position.
Place the saw on a firm, level surface where
To avoid back injury, hold the tool close to your there is plenty of room for handling and proper-
body when lifting. Bend your knees so you canly supporting the workpiece.
lift with your legs, not your back. Lift by using
Bolt, nail or clamp the saw to its support.
the cast-in carry handles at each side of the bot-
tom of the base.Be careful not to over drive nail
!CAUTION
or over torque the bolt. This could
Never carry the tool by the slide rails, this
crack foot or damage base.
may cause blade misalignment.
Never carry the miter saw by the power cord or
Mounting Applications
Workbench1.Each of the four mounting holes should be bolt-
ed securely using 7/16" bolts, lock washers, and
Mount the saw using either the four bolt holes (7/16")hex nuts (not included).
or the four nail holes to the workbench (Figure 15).
2.Locate and mark where the saw is to be mount-
Check for clearance to the left and right of the saw.
ed.
3.Drill four (4) 7/16" diameter holes through work-
bench.
BOSCH
4.Place the slide compound miter saw on the
Nail Holeworkbench aligning holes in base with holes
Bolt Hole
Bolt Hole drilled in workbench. Install bolts, lock wash-
Nail Hole
ers and hex nuts.
Supporting surface where saw is to be mounted
should be examined carefully after mounting to insure
that no movement can occur during use. If any tipping
50or walking is noted, secure the workbench or stand
45
50454030before operating the slide compound miter saw.3540
3530
2520151050
Bolt Holes
Nail Holes
Figure 15. Workbench Mounting
17. |
ACEC
