Adjustments
Disconnect plug from power source
!WARNINGCalibrating Blade at 0!
before performing any assembly,
adjustment or repair to avoid possible injury.(90! to the table)
NOTE: Your miter saw was completely adjusted atNOTE: Calibrating the bevel setting also automatical-
the factory. However, during shipment, slight mis-ly calibrates the 33.9! stops.
alignment may have occurred. Check the following
settings and adjust if necessary prior to using this1. Remove rear cover to expose bolts.
miter saw.2. Lift bevel lock lever to release bevel lock.
3. Loosen bolt heads OA� and OB� with 10mm open-
Checking 0! BevelFigure 2
Adjustment4. Place 4mm Allen wrench bit onto multi-purpose
tool and loosen setscrew OD� at least 3 full turns
1. Lower head assembly and engage head assemblyFigure 2
lock pin.
2. Slide head assembly completely to the back and
tighten the rail lock knob.
3. Rotate table to 0! miter positionC
4. Pull up bevel lock lever to unlock bevel.
A
5. Check position of bevel range selector knob, it
should be at the 0!-45! position.
6. Tilt the saw assembly to the left, then rotate saw
assembly to the right until you feel the stop in the
vertical position. This is where the saw is currentlyB
set for the 0! bevel cut.
E
Use a combination square to check blade square-
ness to the table. Place the square on the table andD
press it against the blade. If the blade does not
figure 1
low the calibrating procedure.Figure 2. Calibrating Blade at 0 degrees
(90! to the table)
5. Place combination square on table and against
See figure 1
6. While rotating bolt head OC�, watch the saw blade
tilt until it is aligned with the combination square.
7. Tighten setscrew OD�.
8. Tighten 10mm bolt heads OA� & OB�
9. Check and adjust bevel pointers to 0 degrees on
Tableeach side of bevel scale.
10. Push down bevel lock lever until you feel the
lever snap into the locked position.
Blade
CombinationBevel Lock
SquareLever
Figure 1. Blade Square to Table
13. |
ACEC
