depressing the ?-? button after firstInterrupting or Pausing Timer
selecting the timer function. TheThe timer function may be interrupted
time could then be adjusted downor paused at anytime by turning the
from 30 minutes by depressing therotary switch to the Off position, ?O/
?-? button.Off.? The operating time will stop at
the current time. To restart simply turn
Using the Rotary Switchthe rotary switch back on to the
Once the attachment is in place, the
speed of its moving components candesired speed. The appliance will then
be controlled through the use of thecontinue to operate for the remaining
rotary switch at the front of the powertime or until again interrupted.
unit. See figure 2a. The rotary switch
has six positions:Stopping Timer Function
The timer function can be turned off at
a. ?M,? a momentary ?pulse? positionany time by depressing the ?time off?
that provides full speed and powerbutton, see figure 2b. If the rotary
for the time it is held in position.switch is On, the power unit will
b. ?O/Off,? the Off position.continue to run at the selected speed
c. Four speeds labeled 1, 2, 3 and 4.until turned off manually.
Speed 1 is the lowest speed. The
speed increases with eachElectronic Safety Control
succeeding step up to the highest
speed, speed 4. The selectedThe Bosch Concept 7400 Kitchen
speed is also indicated by the barMachine incorporates an electronic
at the top of the digital display, seesafety control to protect the motor. If
figure 2c, 1. The bar is broken intothe safety becomes activated, the
four separate segments. For Speedpower unit will shutoff and an error
1 a single segment is illuminated,code will be displayed, see figure 2c,
for Speed 2 two segments are3. See TROUBLESHOOTING at the
illuminated. This continues untilback of this manual if the electronic
Speed 4 when all four segments atsafety control should become
the top of the display areactivated.
illuminated.
6. Turn power unit off.
Timer with Rotary SwitchWhen your work with the attachment
If the timer function had been turnedis completed or the capacity of the
on prior to switching the power unit onbatch-feed attachment has been
and setting the speed with the rotaryreached, turn the power unit to the Off
switch, the power unit will run for theposition, ?O/Off.? If you are using the
time selected and then turn itself off.timer function, turning the rotary
The digital display will show ?00:00?switch to Off will stop the timer at the
and the colon between the minutes andamount of time remaining.
seconds, as well as the four speed
segments, will flash. The rotary switch 7. Remove the attachment.
should then be turned to the Off
position, ?O/Off.? The timer willRemove the attachment from the
automatically turn itself off.power unit, per instructions for the
specific attachment being used.
8 |
ACEC
